We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Green 90-degree M.2 adapter board converting 2230 to 2280 NVME for ROG Ally

Fervit

Fervit M.2 2230 to 2280 NVME PCIe 4.0 Adapter for ROG Ally Green 90-degree

SKU CH-9906-SH79Q

A 90-degree green adapter board converts the ROG Ally's 2230 M.2 slot to accept a 2280 NVME PCIe 4.0 drive for higher capacity and speed

  • Upgrades ROG Ally storage from 2230 to 2280 NVME
  • 90-degree green board fits the handheld chassis precisely
  • PCIe 4.0 interface enables faster transfer speeds
  • Compact 3.3x2.4x.4 cm design saves internal space
  • Requires technical skill for installation and system cloning

2230-to-2280 NVME upgrade for ROG Ally

This adapter lets ROG Ally owners replace the factory 2230 M.2 drive with a full-length 2280 NVME SSD. The green 90-degree board routes the longer module flat against the handheld's chassis so the back cover closes cleanly. It targets gamers and power users who need more capacity and PCIe 4.0 throughput than the stock drive provides.

Green 90-degree short board, 3.3 x 2.4 x .4 cm

The compact PCB uses a right-angle M-key connector to sit flush inside the tight Ally cavity. Build quality relies on a standard four-layer stack with gold fingers and a soldered retention post for the 2280 drive. No cables or brackets are included; the board mounts directly into the existing M.2 slot and secures with the device's original screw.

Replaces the stock 2230 module when capacity

Cloning the original system drive requires booting the Ally, attaching the new SSD through the adapter, and running a migration tool such as DiskGenius. The upgrade is worthwhile once the factory drive fills up or becomes a bottleneck, but it demands disassembly confidence and comfort with drive-cloning software.

Highlights

  • Upgrades ROG Ally storage from 2230 to 2280 NVME
  • 90-degree green board fits the handheld chassis precisely
  • PCIe 4.0 interface enables faster transfer speeds
  • Compact 3.3x2.4x.4 cm design saves internal space
  • Requires technical skill for installation and system cloning

Specifications

BrandFervit

Questions about this item

What PCIe standard does this adapter support and what speed ceiling does it impose?

The adapter carries a PCIe 4.0 x4 M-key interface, so the installed 2280 NVME SSD is limited to PCIe 4.0 transfer rates.

What are the board dimensions and will it clear the ROG Ally chassis?

The green 90-degree short board measures 3.3 x 2.4 x 0.4 cm and is shaped to fit inside the ROG Ally without fouling the case.

How is the adapter installed and which cloning step is often missed?

Mount the 2280 SSD on the board, insert the assembly into the Ally, boot the original system, then run DiskGenius "system migration" to clone the OS before swapping drives.

New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.