We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Black Y-cable with two USB-A plugs and one micro USB 5-pin connector, 60cm length

Fervit

Fervit Dual USB-A to Micro USB 5-Pin Y-Cable 60cm Extra Power

SKU CH-QX96-E77DW

Y-cable draws power from two USB-A ports to run a Micro-USB device at up to 10 W while transferring data at 480 Mbps

  • Dual USB-A ports supply extra power for demanding devices
  • One port handles USB 2.0 data at 480 Mbps while the second adds power only
  • Delivers up to 5 V 2 A for a 10 W peak when both ports are used
  • 60 cm length suits portable 2.5 inch drives and other peripherals
  • Backwards compatible with USB 1.1 Low-Speed at 1.5 Mbps

Dual USB-A Y-Cable for Extra Power

This Fervit cable connects a single Micro USB 5-Pin device to two USB Type-A ports on a host. One connector carries both USB 2.0 data and power while the second supplies extra power only. It is intended for users whose portable 2.5 drives or similar peripherals cannot start reliably from one port.

Thermals Noise and Power Draw

The assembly draws up to DC 5V 2A when both USB-A plugs are seated, yielding a peak of 10W. No active cooling is present so operation is silent. Power consumption scales with the attached device and the host ports’ current limits.

Bundled Accessories and Software

No software, drivers or additional accessories are included in the package. The cable itself is the complete solution; it enables higher current delivery without configuration. Buyers who need a longer reach or a different device connector will require a separate cable.

Highlights

  • Dual USB-A ports supply extra power for demanding devices
  • One port handles USB 2.0 data at 480 Mbps while the second adds power only
  • Delivers up to 5 V 2 A for a 10 W peak when both ports are used
  • 60 cm length suits portable 2.5 inch drives and other peripherals
  • Backwards compatible with USB 1.1 Low-Speed at 1.5 Mbps

Specifications

BrandFervit

Questions about this item

How do I plug in the Y-cable so the extra-power USB-A connector actually feeds the 2.5 drive?

Insert the data-and-power USB-A into the host port first, then connect the second USB-A to a separate powered port; reversing the order leaves the Micro-USB 5-pin device without the combined 5 V 2 A supply.

Will the Micro-USB 5-pin plug wear out and need replacing under daily connect-disconnect cycles?

The Micro-USB 5-pin connector is rated for standard USB 2.0 mating cycles; if the spring tabs loosen or the port feels slack, replace the cable rather than the drive.

At what point does the 10 W peak limit throttle a sustained transfer to a portable 2.5 drive?

Continuous draws above 5 V 2 A (10 W) will cause the host ports to current-limit, dropping the link to USB 1.1 1.5 Mbps until the load falls back within spec.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.