We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Square black 60mm frame fan with single wire plug

Fans

Fans Mitsubishi servo fan MMF-06G24TS-MM1 24V 0.11A 60x60x25mm

SKU CH-NM4B-4G7M0

A 24V servo cooling fan measuring 60x60x25mm with 0.11A current draw for CNC machinery

  • Original Mitsubishi servo fan for CNC reliability
  • 24 V 0.11 A draws minimal power
  • 60×60×25 mm fits tight enclosures
  • Single-wire plug simplifies wiring
  • Brand-new condition ensures full service life

Mitsubishi servo fan MMF-06G24TS-MM1

The Mitsubishi MMF-06G24TS-MM1 is a 24 V axial fan measuring 60 by 60 by 25 mm. It draws 0.11 A and uses a single-wire plug. The unit is built for CNC and servo drive cooling in industrial equipment.

Suited for CNC and servo drive cooling

This fan fits machines that specify the MMF-06G24TS-MM1 or NC5332H72 part number and a 24 V supply. It is not for builds needing a different voltage, a two-wire or PWM connector, or a larger frame size.

24 V 0.11 A continuous operation

At 24 V the motor runs continuously in drive cabinets and similar enclosures. Headroom ends if the supply drifts from 24 V, if the connector pinout does not match the single-wire plug, or if the mounting pattern differs from the 60 mm square footprint.

Highlights

  • Original Mitsubishi servo fan for CNC reliability
  • 24 V 0.11 A draws minimal power
  • 60×60×25 mm fits tight enclosures
  • Single-wire plug simplifies wiring
  • Brand-new condition ensures full service life

Specifications

No published specifications for this item yet.

Questions about this item

Does this 24 V fan need a separate 24 V power supply to run?

Yes, the fan is rated for 24 V and 0.11 A, so a compatible 24 V DC source must be provided.

Will the 60 mm square frame and single-wire plug fit the same cut-out and connector as my existing Mitsubishi NC5332H72 unit?

The housing is 60×60×25 mm with a 1-wire plug, matching the original NC5332H72 mechanical and electrical interface.

How can I confirm the fan is operating correctly after installation?

Measure 24 V across the supply leads and verify approximately 0.11 A current draw while the blades spin freely.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.