We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Square black 60x60x15mm case fan with four-pin connector

Fans

Fans KF0615H1HK-R 12V 2.3W 4-Pin 60x60x15mm case fan

SKU CH-7WJH-NCEZ1

A 60×60×15 mm case fan drawing 2.3 W at 12 V with a 4-pin PWM connector

  • 12 V DC power for direct PSU connection
  • 3 W draw keeps system power budget low
  • 4-pin PWM header enables precise speed control
  • 60 × 60 × 15 mm frame fits standard 60 mm mounts

Compact 60 mm PWM fan for tight builds

This 60 by 60 by 15 mm case fan fits small-form-factor chassis and rack units where larger rotors cannot mount. It runs on a 12 V four-pin PWM header so the motherboard can scale speed to thermal load. The 2.3 W rating keeps power draw low for dense multi-fan arrays. Builders who need higher static pressure at this footprint should look elsewhere.

50 mm impeller with four-wire control

The 50 mm blade diameter sits inside the standard 60 mm frame and connects via a keyed 4-pin plug that carries both power and tachometer signal. Screw holes align with common 60 mm mounting patterns so installation uses ordinary case hardware. No RGB lighting or extra cables are included, keeping cable routing simple in cramped enclosures.

Highlights

  • 12 V DC power for direct PSU connection
  • 3 W draw keeps system power budget low
  • 4-pin PWM header enables precise speed control
  • 60 × 60 × 15 mm frame fits standard 60 mm mounts

Specifications

No published specifications for this item yet.

Questions about this item

What does the 4-pin PWM interface control on this fan?

The 4-pin connector enables pulse-width modulation speed control so the motherboard can adjust RPM based on temperature.

Will this 60 mm by 60 mm by 15 mm frame fit a standard 60 mm mounting pattern?

Yes, the 60 x 60 mm square frame matches the common 60 mm hole spacing used on many cases and heatsinks.

New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.