We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Square 60 by 60 by 15 mm black frame fan with four wires and centre sticker

Fans

Fans D06R-12PS1 60x60x15mm 12V PWM double ball-bearing case fan

SKU CH-3PY0-PXBR6

A 60 mm square, 15 mm thick case fan with 12 V PWM control and double ball bearings

  • PWM control adjusts speed to thermal demand
  • Double ball-bearing design extends operating life
  • 60 × 60 × 15 mm fits compact chassis
  • 12 V 0.20 A draws minimal power

Compact 60 mm PWM fan for tight builds

This 60 by 60 by 15 millimetre case fan runs on 12 volts and draws 0.20 amps. The four-wire PWM connector lets the motherboard control speed automatically. Double ball-bearing construction targets longer service life in continuous operation. It suits small-form-factor cases or auxiliary cooling spots where larger fans will not fit.

Simple four-pin install with clearance check

The standard PWM header plugs directly into most motherboards without adapters. Verify that the mounting holes match the 60 millimetre spacing before ordering. The 15 millimetre thickness can foul low-profile coolers or crowded PCIe slots in some layouts. Builders needing higher static pressure or larger airflow volumes should look at bigger frame sizes.

Highlights

  • PWM control adjusts speed to thermal demand
  • Double ball-bearing design extends operating life
  • 60 × 60 × 15 mm fits compact chassis
  • 12 V 0.20 A draws minimal power

Specifications

No published specifications for this item yet.

Questions about this item

How can I confirm the D06R-12PS1 is spinning at the correct speed after installation?

Connect the 4-wire PWM cable to a motherboard header and monitor the RPM reading in BIOS or fan-control software; the fan should respond to duty-cycle changes.

What comes with the D06R-12PS1 and what must I source separately?

The box contains one 60x60x15 mm 12 V 0.20 A double ball-bearing fan with a 4-wire PWM connector; mounting screws and any fan hub or splitter are not included.

New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.