Fans
Fans AFB0912SH-A 9225 92x92x25mm 12V 1.00A dual ball bearing 4-wire PWM case fan
A 92 mm square, 25 mm thick PWM case fan with dual ball bearings running on 12 V at 1.00 A
- Dual ball bearing extends operational lifespan
- 12 V 1.00 A delivers strong airflow
- 4-wire PWM enables precise speed control
- 92 x 92 x 25 mm fits standard mounts
92 mm PWM axial fan
This 92x92x25 mm fan runs on 12 V and draws 1.00 A. A 4-wire PWM connection allows speed control from the motherboard or fan controller. Dual ball bearings support continuous operation in server or workstation chassis.
Suited for 92 mm mounts needing PWM control
Builders with smaller or larger frame requirements cannot use this size. Systems without a 4-pin PWM header lose automatic speed regulation. Users seeking lower noise at idle may prefer a fan with a lower minimum RPM.
Highlights
- Dual ball bearing extends operational lifespan
- 12 V 1.00 A delivers strong airflow
- 4-wire PWM enables precise speed control
- 92 x 92 x 25 mm fits standard mounts
Specifications
No published specifications for this item yet.
Questions about this item
Will the 92 mm frame and 12 V PWM connector fit the mounting holes and header on my older motherboard?
The fan uses a standard 92 mm square frame with 25 mm thickness and a 4-wire PWM connector that plugs into any 12 V motherboard header.
How can I confirm the dual ball bearing fan is running at the correct speed after installation?
Check the RPM reading in BIOS or fan-control software; the 4-wire PWM signal reports real-time speed so you can verify it matches the curve you set.
New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
Black Box Corporation
Black Box Corporation CAT6 EZ-RJ45 Modular Plugs 100-Pack
$95.99
0.00115713BTC
In stock
