Explus-C
Explus-C 05416 Full Motion TV Mount 23-55in VESA 400x400 66lbs
Full-motion wall mount holds 23 to 55 inch TVs up to 66 lbs with 15 degree tilt, 90 degree swivel and VESA patterns to 400x400
- Mount StyleWall Mount
- Wide viewing angles with +90° to -90° swivel and +15° to -15° tilt
- Fits 23 to 55 inch screens up to 66lbs
- Quick 30 minute install on a single wood stud
- Cable clips keep wires tidy and out of sight
- VESA patterns from 75x75 up to 400x400 supported
TV Mount for 23-55 Inch Screens
This full motion wall mount fits most flat panel TVs from 23 to 55 inches weighing up to 66lbs. The articulating arm provides tilt from +15° to -15° and swivel from +90° to -90° for flexible viewing angles. A keyhole VESA plate simplifies attaching the television to the bracket. Integrated cable clips keep wiring organised and tidy.
Replaces Fixed or Tilt-Only Brackets
Upgrade from a stationary mount when you need to pull the screen away from the wall or swivel it toward different seating areas. The single articulating arm suits installations on a single wood stud where a dual-arm design would not fit. Buyers who require a dual-arm mount for heavier loads or greater extension distance should consider other options.
Sustained Load on Single Stud
The mount is engineered to hold the maximum 66lb load continuously on a single wood stud without sagging over time. All mounting hardware is included and pre-divided to support a typical 30 minute installation. The low-profile arm maintains its set position reliably during daily adjustment cycles.
Highlights
- Wide viewing angles with +90° to -90° swivel and +15° to -15° tilt
- Fits 23 to 55 inch screens up to 66lbs
- Quick 30 minute install on a single wood stud
- Cable clips keep wires tidy and out of sight
- VESA patterns from 75x75 up to 400x400 supported
Specifications
| Mount Style | Wall Mount |
|---|
Questions about this item
What VESA hole patterns does the 05416 mount support?
The mount fits VESA 75x75, 100x100, 200x100, 200x200, 300x300 and 400x400 mm patterns.
Which step do installers most often miss when mounting on a single wood stud?
They skip pre-drilling the pilot hole in the stud centre before driving the lag bolt, which can split the wood or leave the mount loose.
What part of the 05416 should be checked periodically after installation?
Re-tighten the lag bolt into the wood stud and the VESA plate screws every few months, as vibration can loosen them over time.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.



