EVESKY
EVESKY C9200-NM-4G Catalyst 9200 Network Module 4 x 1GE SFP+
Adds four Gigabit SFP+ ports to a Catalyst 9200 switch via plug-in module
- FeaturesC9200-NM-4G For Catalyst 9200 Network Module 4 x 1GE SFP+ Wi
- Adds four Gigabit SFP+ ports to Catalyst 9200
- Hot-swappable module installs without powering down the switch
- Supports fibre or copper transceivers for flexible uplinks
- Expands connectivity for aggregation or access-layer designs
- Plug-in form factor preserves front-panel ports on the host switch
EVESKY C9200-NM-4G Network Module
The EVESKY C9200-NM-4G is a plug-in network module designed for Cisco Catalyst 9200 series switches. It provides four additional Gigabit Ethernet ports using SFP+ transceivers for fibre or copper connectivity. This expansion module adds wired uplink or downlink capacity to a compatible switch chassis. It is a new component intended for network infrastructure upgrades.
Suits Catalyst 9200 expansion needs
This module suits administrators adding four 1 GbE SFP+ ports to a Catalyst 9200 switch without replacing the base unit. It does not suit buyers who need port speeds above 1 GbE or a higher port count than four. It is not a standalone switch and requires a supported Catalyst 9200 chassis to operate.
Four 1GE SFP+ ports decide fit
The single specification that decides fit is the provision of exactly four 1 Gigabit Ethernet SFP+ interfaces. Verify the target Catalyst 9200 model accepts this module and that the required SFP+ transceivers are available separately. No other interface types or speeds are included on this module.
Highlights
- Adds four Gigabit SFP+ ports to Catalyst 9200
- Hot-swappable module installs without powering down the switch
- Supports fibre or copper transceivers for flexible uplinks
- Expands connectivity for aggregation or access-layer designs
- Plug-in form factor preserves front-panel ports on the host switch
Specifications
| Model | C9200-NM-4G |
|---|---|
| Features | C9200-NM-4G For Catalyst 9200 Network Module 4 x 1GE SFP+ Wired Plug-in module |
Questions about this item
How do I install the C9200-NM-4G module into a Catalyst 9200 switch, and what step is often missed?
Power down the switch, slide the module into the network module slot until it clicks, then secure the captive screws; the step often missed is tightening both screws fully to ensure proper electrical contact.
What maintenance or replacement will the C9200-NM-4G need over time?
The module itself has no moving parts; maintenance is limited to keeping the SFP+ cages clean and replacing any failed SFP+ transceivers inserted into the four ports.
What throughput limit appears first on the C9200-NM-4G during sustained heavy traffic?
Each of the four ports is limited to 1 Gbps line rate, so aggregate sustained throughput cannot exceed 4 Gbps across the module.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
IBM
IBM 00JX058 Xeon E5-2640 v3 8-core 2.60 GHz 20 MB L3 90 W switch module
$217.99
0.00259031BTC
In stock
