EN-Labs
EN-Labs IDE23SATA8 SATA Power Splitter Cord 15-pin Male to 2 Female 8 inch 20AWG
Splits one 15-pin SATA power connector into three with an 8-inch 20AWG copper cable supporting 12V, 5V and 3.3V devices
- TypeCable Splitters
- ColorMulti-Color
- Length6" - 10"
- SpecificationsType :SATA power splitter cable Length:8 inch Conductor:20AW
- Connector Number4
- Terminal GenderMale to Female
- Powers three drives from one SATA connector
- 20 AWG copper conductor delivers stable current
- 8 inch length keeps cable runs tidy
- Male plug with gender changer fits tight ports
- Supports 12V 5V 3.3V SATA devices
One cable powers three drives
The EN-Labs IDE23SATA8 is an 8 inch SATA power splitter built with 20AWG copper conductors. It accepts a single 15-pin male connector and provides two additional 15-pin female ports. A pass-through gender changer on the input side keeps the chain intact. The cord suits builders adding SSDs, HDDs or optical drives without extra power supply leads.
Steady delivery across all ports
Each branch carries 12V, 5V and 3.3V rails simultaneously so every attached device receives its rated voltage under continuous load. The 20AWG copper cores limit resistance over the short run preventing voltage sag when multiple drives spin up together. No active circuitry is present so reliability depends on the source supply and connector seating.
Plug in and route the short tails
Installation is a simple push fit onto the power supply lead and each drive backplane. The 8 inch length keeps cable clutter low but demands that drives sit close to the splitter or to each other. Misaligned pins or loose latch engagement are the typical faults so verify each connector clicks home before powering on.
Highlights
- Powers three drives from one SATA connector
- 20 AWG copper conductor delivers stable current
- 8 inch length keeps cable runs tidy
- Male plug with gender changer fits tight ports
- Supports 12V 5V 3.3V SATA devices
Specifications
| Brand | En-Labs |
|---|---|
| Model | IDE23SATA8 |
| Type | Cable Splitters |
| Color | Multi-Color |
| Length | 6" - 10" |
| Specifications | Type :SATA power splitter cable Length:8 inch Conductor:20AWG Copper Connector A: SATA15-pin Male w/ female Gender Changer Connector B:2 x SATA 15-pin Female Power supports:12V/5V/3.3V SATA devices |
| Connector Number | 4 |
| Terminal Gender | Male to Female |
| Features | 3 way SATA power splitter adapter. This Y cable has pass through SATA power connector on one end daisy chained to 2 female SATA power connectors on the other allowing you to power up to 3 SATA devices. For use with SATA drives and SATA power supplies. SATA power connectors provide a Slim profile and tri-voltage 3. 3V 5V & 12V. |
Questions about this item
Does the 20AWG copper conductor handle the 12V, 5V and 3.3V lines without overheating when three drives run all day?
The 20AWG copper wire is rated for the 12V, 5V and 3.3V rails that SATA devices draw, so continuous operation across three drives stays within normal thermal limits.
What power connector must my PSU already provide for the male end to plug in?
Your power supply needs a standard 15-pin SATA power connector; the splitter's male end mates directly with it.
Will the pass-through male connector still fit alongside older Molex-to-SATA adapters I already use?
Yes, the pass-through 15-pin male connector occupies the same space as a regular SATA power plug, so it sits next to legacy adapters without interference.
New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
Black Box Corporation
Black Box Corporation CAT6 EZ-RJ45 Modular Plugs 100-Pack
$95.99
0.00114286BTC
In stock
