We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Black sleeved 16 inch LP4 to four PWM fan splitter cable with RPM feedback

EN-Labs

EN-Labs Black Sleeved 16" LP4 to 4 x PWM Fan Splitter Cable

SKU CH-95CX-AEG9D

Splits one LP4 power connector into four PWM fan headers with a single RPM feedback line for synchronised speed control

  • TypeFan power splitter cable
  • Length16"
  • Cable Length1.33 ft.
  • Connector Number6
  • Powers four PWM fans from one Molex connector
  • Only one fan reports RPM for accurate monitoring
  • All fans follow single PWM signal for synchronised speed
  • 26AWG tinned copper wire with black sleeved jacket
  • 16 inch length suits most case layouts

Power Source and Fan Capacity

This splitter cable draws 12V DC power from a single 5.25-inch Molex LP4 connector on the power supply. It distributes that power to four PWM fans while taking a speed signal from just one fan through a TX4 female header plugged into the motherboard.

Builders Needing Synchronised PWM Control

The cable suits builders who want four fans to follow one motherboard PWM header and report a single RPM reading. It is not for systems that require individual tachometer feedback from every fan or that need to power 5V DC fans from the same lead.

Sleeved Jacket and Wiring Layout

A black sleeved jacket made from 26AWG tinned copper UL1007 wire covers the 16-inch length for tidier routing inside the case. Three of the four TX4 male connectors omit the tachometer pin so the motherboard receives one clean RPM signal while all four fans still follow the shared PWM curve.

Highlights

  • Powers four PWM fans from one Molex connector
  • Only one fan reports RPM for accurate monitoring
  • All fans follow single PWM signal for synchronised speed
  • 26AWG tinned copper wire with black sleeved jacket
  • 16 inch length suits most case layouts

Specifications

TypeFan power splitter cable
Length16"
Cable Length1.33 ft.
Connector Number6

Questions about this item

Will this splitter draw power from my PSU's Molex LP4 connector and still report RPM to the motherboard?

Yes, the LP4 male plugs into a 5.25" Molex 12 V rail for power while the TX4 female connects to a motherboard PWM header so one fan's tach signal is reported back.

If I keep three-pin fans in the case, will they still spin from the PWM signal?

The three TX4 male connectors accept both 4-pin PWM and 3-pin fans; all four fans follow the motherboard PWM curve, though only the fan on the full 4-pin lead sends RPM data.

How can I confirm the cable is passing the correct RPM reading after installation?

In BIOS or monitoring software, the header will show a single RPM value from the fan attached to the fully pinned TX4 male connector while the other three fans run at the same PWM duty cycle.

New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.