Advance Tabco
Advance Tabco FC-1-1818-X Wall Mounted Sink 18 in x 18 in, 304
- Silver
$790.99
0.00936138BTC
In stock
Elemental LED
Elemental LED VLM60W-12-LPM LO-PRO Mini LED driver ballast 12V 60W
Compact 12 V LED driver delivers 60 W in a space-saving junction-box combo
- typeBallasts
- Highest efficiency power supply in smallest footprint
- 12V 60W output powers low-voltage LED installations
- UL Listed components ensure safety compliance
- Precision potting conducts heat uniformly across driver body
- Advanced 3D design minimises noise paths for reliable performance
Compact 12 V 60 W driver for low-voltage LED runs
This LO-PRO Mini unit combines a junction box and constant-voltage driver in one housing. It delivers 12 V at up to 60 W for strip, tape or module lighting in residential and light-commercial projects. The potted construction spreads heat evenly across the case for quiet, fan-free operation.
Replaces bulky magnetic transformers
The ultra-small footprint fits inside tight coves, under cabinets or behind cornices where older gear will not go. The jump is worth it when space is at a premium and you need UL-listed safety without a separate enclosure. Installers who only need a simple on-off circuit without dimming will find the fixed-output design a direct, hassle-free swap.
Mounts with two screws
Strip the low-voltage leads, land them on the driver terminals, and close the cover — no extra wiring compartments required. The most common issue is exceeding the 60 W limit; add a second driver rather than overloading this one. Verify the load voltage matches 12 V exactly, as the unit does not auto-range.
Highlights
- Highest efficiency power supply in smallest footprint
- 12V 60W output powers low-voltage LED installations
- UL Listed components ensure safety compliance
- Precision potting conducts heat uniformly across driver body
- Advanced 3D design minimises noise paths for reliable performance
Specifications
| Brand | DIODE LED |
|---|---|
| type | Ballasts |
Questions about this item
What mounting space does the LO-PRO Mini driver and junction box combo require?
The driver uses a compact potted housing designed for minimal footprint; the entire bottom surface acts as a thermal path, so it must be mounted flat against a solid surface with no air gap.
How is the 12V 60W driver wired into a low-voltage LED circuit?
Connect the AC supply leads inside the integrated junction box, then run the 12 V DC output leads to the LED load; the step often missed is torquing the box cover screws to maintain the UL-listed enclosure rating.
When should the driver be replaced if it runs continuously at 60W?
The potted thermal design spreads heat across the full case; if the housing becomes too hot to touch or the LEDs begin to flicker, the internal components have likely reached end of life and the unit should be swapped.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
