Advance Tabco
Advance Tabco FC-1-1818-X Wall Mounted Sink 18 in x 18 in, 304
- Silver
$790.99
0.00934248BTC
In stock
Elemental LED
Elemental LED DIODE LED DI-TD-24V-80W OMNIDRIVE Ballast 80W 24V
A 24 V electronic dimmable driver delivering 80 W with smooth 100 % to 10 % dimming across TRIAC, MLV, ELV and incandescent controls
- typeBallasts
- Smooth dimming from 100% down to 10%
- Built-in electronic filter eliminates flicker
- Compatible with TRIAC, MLV and ELV dimmers
- 80W output powers 24V LED installations
- California Proposition 65 warning included
24 V 80 W OMNIDRIVE ballast
This 24 V electronic dimmable driver supplies up to 80 W of power for LED lighting installations. It is intended for electricians and integrators who need a single power supply that works with a wide range of dimming controls. The unit is new and ships directly from the manufacturer.
Dimming compatibility range
The driver dims smoothly from 100 % down to 10 % without flicker when paired with TRIAC, magnetic low voltage, electronic low voltage or incandescent and halogen dimmer switches. It also supports three-way, four-way and five-way switching circuits. An internal electronic filter removes flicker across the dimming curve.
Wiring and safety notes
Connections follow standard low-voltage wiring practices for 24 V LED loads and the listed dimmer types. The product carries a California Proposition 65 notice because it contains a chemical known to the state to cause birth defects or other reproductive harm. Installers should verify that the total connected load does not exceed the 80 W rating.
Highlights
- Smooth dimming from 100% down to 10%
- Built-in electronic filter eliminates flicker
- Compatible with TRIAC, MLV and ELV dimmers
- 80W output powers 24V LED installations
- California Proposition 65 warning included
Specifications
| Brand | DIODE LED |
|---|---|
| type | Ballasts |
Questions about this item
What does the 80W rating mean for the LED load I can connect?
The driver can power up to 80W of 24V LED tape or fixtures, so the total wattage of connected strips must not exceed that figure.
Which dimmer types work with the OMNIDRIVE interface?
It is compatible with TRIAC, magnetic low voltage, electronic low voltage and incandescent or halogen dimmer switches, plus standard on/off or multi-way switching.
What mounting provision does the driver need?
The unit is designed to be installed inside a suitable electrical enclosure or junction box with adequate ventilation for heat dissipation.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
