We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
White PLA+ filament spool, 1.75mm diameter, 1kg weight

ELEGOO PLA Plus Filament 1.75mm White 1kg

SKU CH-95D9-ARR1W

1.75 mm PLA+ filament with ±0.02 mm accuracy, low warpage and high impact strength on a 1 kg spool

  • ColorWhite
  • MaterialPolylactic Acid
  • Diameter1.75
  • Weight1 kilograms
  • Tougher material for functional parts with higher impact strength
  • Neat mechanical winding reduces tangles and line breakage
  • Precise 1.75mm diameter within +/- 0.02mm tolerance
  • Smooth glossy finish from strong layer bonding at lower temps
  • Vacuum-sealed dry spool prevents clogging and bubbling

ELEGOO PLA Plus 1.75 mm Filament

ELEGOO PLA Plus is a 1.75 mm polylactic acid filament supplied on a 1 kg spool. The material is formulated for higher toughness and impact strength while keeping warpage and shrinkage low. It is intended for makers who need reliable results when printing functional parts or general projects.

Mechanical winding and dimensional accuracy

Full mechanical winding with manual inspection keeps the spool neatly wound and reduces tangles, snaps and line breakage. Diameter tolerance is held to +/- 0.02 mm, giving consistent feeding through most 1.75 mm FDM 3D printers. The filament arrives fully dried and vacuum sealed to protect against moisture and dust.

Printing temperature and surface finish

Recommended nozzle temperature ranges from 190 to 230 °C, allowing lower printing temperatures for easier use. Accurate deposition and strong layer bonding produce a glossy surface without layer delamination. The sealed packaging prevents clogging and bubbling during normal operation.

Highlights

  • Tougher material for functional parts with higher impact strength
  • Neat mechanical winding reduces tangles and line breakage
  • Precise 1.75mm diameter within +/- 0.02mm tolerance
  • Smooth glossy finish from strong layer bonding at lower temps
  • Vacuum-sealed dry spool prevents clogging and bubbling

Specifications

BrandELEGOO
ColorWhite
MaterialPolylactic Acid
Diameter1.75
Weight1 kilograms

Questions about this item

What nozzle temperature range does the 1.75 mm PLA Plus filament need?

The recommended nozzle temperature is 190 - 230 °C for reliable extrusion and layer bonding

What spool dimensions should I check so the 1 kg roll fits my printer holder?

The spool weighs 1 kg (2.2 lbs) and uses standard 1.75 mm winding; verify your holder accepts that width and weight

How do I load the filament without causing the first-layer adhesion issues users sometimes see?

Preheat the nozzle to 190 - 230 °C, purge until flow is even, then start the print; the vacuum-sealed spool is already dry so no extra drying is needed

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.