We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Eiki projector lamp module with housing, new condition

EIKI

EIKI LC-XG250 projector lamp 300W POA-LMP105

SKU CH-MZNW-2P0G3

A 300 W replacement lamp module with 2,000-hour normal and 3,000-hour economy life, supplied as a pre-assembled housing for quick installation

  • TypeProjector Lamp
  • Wattage300W
  • Lamp Life2,000 (Normal) - 3,000 (Economy) Hrs.
  • Ready to install with pre-assembled bulb and housing
  • 300W P-VIP lamp delivers specified brightness
  • 2000 hours normal mode lamp life
  • 3000 hours economy mode extends usage
  • Manufactured to ISO9001 quality standards

Eiki LC-XG250 lamp module

This replacement lamp module fits the Eiki LC-XG250 projector and uses a new Philips P-VIP 300W bulb inside a complete housing. It is sold new and arrives fully assembled so the projector can return to service immediately. The part matches the manufacturer reference POA-LMP105. It suits technicians or owners who need a direct swap without sourcing separate components.

Rated output and lamp life

The lamp draws 300W and is rated for 2,000 hours in normal mode or 3,000 hours in economy mode. Brightness will gradually decline as the hours accumulate, so plan replacement before the end of the rated interval to maintain consistent image quality. The module is built to ISO 9001 quality standards and each unit is tested for ignition, voltage and run-time before shipping. Sustained heavy use will shorten the practical lifespan compared with the economy rating.

Installation notes and common issues

The assembled housing lets you replace the old module in a single step without handling the bare bulb. Always power down the projector and allow it to cool completely before starting the swap to avoid thermal shock or damage to the connector. The most frequent problem is forgetting to reset the lamp-hour counter in the projector menu after installation, which leaves the replacement warning active. Handle the module by the housing only; oils on the glass can cause hot spots and premature failure.

Highlights

  • Ready to install with pre-assembled bulb and housing
  • 300W P-VIP lamp delivers specified brightness
  • 2000 hours normal mode lamp life
  • 3000 hours economy mode extends usage
  • Manufactured to ISO9001 quality standards

Specifications

BrandEiki
TypeProjector Lamp
Wattage300W
Lamp Life2,000 (Normal) - 3,000 (Economy) Hrs.

Questions about this item

How much heat and power does the 300W P-VIP bulb produce during extended use?

The lamp draws 300 watts and is rated for 2,000 hours in normal mode or 3,000 hours in economy mode, so heat output scales with the selected brightness setting.

Which Eiki projectors accept the POA-LMP105 housing without modification?

This module is built for the LC-XG250 projector; the housing matches that model’s lamp compartment and connector.

Will the 300W replacement strike reliably on an older LC-XG250 ballast?

The lamp is manufactured to ISO 9001 standards and tested for ignition, voltage and run-time on the original ballast design.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.