EIKI
EIKI EIP-X3000N projector lamp 275W 3000 Hrs
Ready-to-install 275 W replacement lamp module rated for 3,000 hours of use
- TypeProjector Lamp
- Wattage275W
- Lamp Life3,000 Hrs.
- Ready-to-install module saves setup time
- 275W Phoenix SHP bulb delivers specified brightness
- 3,000-hour rated life supports extended use
- Manufactured to ISO 9001 quality standards
- Compatible with Eiki EIP-X3000N projectors
Ready-to-install replacement lamp
The EIKI EIP-X3000N is a new 275W projector lamp module that arrives with the bulb already seated in its housing. It matches the ANXR10LP/1 specification for direct fit in compatible EIKI projectors. Installation requires no separate bulb handling.
Phoenix SHP bulb and ISO9001 build
Each unit uses a Phoenix SHP 275W bulb and is manufactured under ISO9001 quality controls. The supplier tests ignition, voltage, beam performance, connections and run-time on every lamp. Three OEM-source versions and one compatible version are offered depending on stock.
3000-hour rated life for daily use
The lamp is rated for 3000 hours of operation, supporting extended daily projection cycles. Buyers needing longer intervals between replacements or higher brightness output should verify alternative models. The pre-assembled housing simplifies swap-out during scheduled maintenance.
Highlights
- Ready-to-install module saves setup time
- 275W Phoenix SHP bulb delivers specified brightness
- 3,000-hour rated life supports extended use
- Manufactured to ISO 9001 quality standards
- Compatible with Eiki EIP-X3000N projectors
Specifications
| Brand | Eiki |
|---|---|
| Type | Projector Lamp |
| Wattage | 275W |
| Lamp Life | 3,000 Hrs. |
Questions about this item
How often will the 275W Phoenix SHP bulb need replacing if I run the projector daily?
The lamp is rated for 3,000 hours of use, so replacement timing depends on how many hours you operate the projector each day.
What component reaches its limit first during long, continuous projection sessions?
The 275W lamp module is the consumable part; after roughly 3,000 hours its brightness drops and it must be swapped out.
How much power does the lamp draw and how much heat should I expect when the projector runs all day?
The lamp draws 275 watts, so the projector will generate a corresponding amount of heat that the internal cooling system must exhaust continuously.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
CHIEF MANUFACTURING CMS018 18" 457 mm Fixed Extension Column projector accessory
- Extension Column
- Projector



