We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Rectangular white LED strobe with clear lens and blunt-cut wires

Ecco

Ecco ED5051W 6 LED Clear Lens Strobe Light

SKU CH-RF8S-9XV14

Six white LEDs produce a SAE J595 Class 1 flashing warning signal for 12–24 V DC permanent mounting with an IP67-rated clear lens

  • TypeFacility & Worksite Safety
  • SAE J595 Class 1 warning visibility
  • 6 white LEDs deliver 9.2 W output
  • IP67 rating resists dust and water
  • 12-24 V DC suits many vehicles
  • Permanent mount with blunt-cut wires

Ecco ED5051W 6 LED Strobe Light

The Ecco ED5051W is a perimeter flashing warning light built for facility and worksite safety. It uses six white LEDs behind a clear rectangular lens to deliver high-visibility alerts. The unit operates on 12-24V DC power and carries an IP67 rating for dust and water resistance. It is designed for permanent installation on universal vehicle types.

Upgrade from incandescent or lower-class beacons

This strobe replaces older rotating or halogen beacons that draw more power and require frequent bulb changes. The LED array consumes 9.2 W while meeting SAE J595 Class 1 output requirements. The jump is worth it when maintenance intervals need extending and electrical load must stay low. It suits fleets standardising on 12-24V DC architectures.

Limits of the SAE J595 Class 1 perimeter format

The single-head rectangular housing mounts flush with a 1 in depth and 5/8 in height profile. Blunt-cut wires require splicing into the vehicle harness for permanent wiring. The clear lens emits white light only; it does not support colour filters or multi-pattern controllers. Buyers needing amber, blue or red output must select a different lens variant.

Highlights

  • SAE J595 Class 1 warning visibility
  • 6 white LEDs deliver 9.2 W output
  • IP67 rating resists dust and water
  • 12-24 V DC suits many vehicles
  • Permanent mount with blunt-cut wires

Specifications

TypeFacility & Worksite Safety
BrandECCO

Questions about this item

What mounting clearance does the 5 3/8 in long rectangular strobe need?

The unit is 5 3/8 in long, 5/8 in high and 1 in deep, so allow at least that footprint plus room for the blunt-cut wire tails to exit cleanly.

How do I wire the blunt-cut leads to a 12-24V DC supply without reversing polarity?

Strip each lead, connect positive to the vehicle's switched 12-24V DC circuit and negative to chassis ground; test flash pattern before final tightening.

When should the IP67-rated LED module be replaced?

Replace the module if water ingress appears behind the clear lens, flash intensity drops noticeably, or the SAE J595 Class 1 output no longer meets worksite visibility requirements.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.