We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Transparent miniature magnetic contactor, 1.44 in wide by 2.28 in high, DIN rail or panel mount, screw terminals

Eaton

Eaton XTMC6A10TD 24V DC 3P Miniature Magnetic Contactor

SKU CH-FEME-QC5C2

A 24 V DC miniature magnetic contactor with three poles, one normally-open auxiliary contact and 6 A inductive current rating for DIN-rail or panel mounting

  • TypeIndustrial Electrical Controls & Automation
  • ColorTransparent
  • IEC miniature contactor fits tight panels at 1.44 in wide
  • 24 V DC coil enables low-voltage control circuits
  • 6 A inductive rating handles motor loads directly
  • 1 NO auxiliary contact provides status feedback
  • DIN rail and panel mounting simplifies installation

Miniature IEC Contactor for Control Circuits

The Eaton XTMC6A10TD is a three-pole miniature magnetic contactor built for industrial electrical control and automation panels. It operates from a 24 V DC coil and provides one normally open auxiliary contact for status feedback or interlocking logic. The unit mounts on DIN rail or directly on a panel and uses screw terminals for secure wiring connections.

Thermals Noise and Power Draw

The contactor carries a full-load inductive rating of 6 A and a resistive rating of 20 A, making it suitable for small motor starters, lighting banks or heating elements. With no enclosure rating, the open frame relies on the host cabinet for airflow and protection. Coil power consumption at 24 V DC is low, and the magnetic actuator runs silently in normal operation.

6 Amp Inductive Current Rating Decides Fit

The 6 A inductive full-load current is the single figure that determines whether this contactor matches your load. If your motor or inductive load exceeds 6 A, this frame size cannot be used and a larger contactor is required. For resistive loads up to 20 A the same unit remains applicable. Buyers needing higher inductive switching capacity must select a different frame.

Highlights

  • IEC miniature contactor fits tight panels at 1.44 in wide
  • 24 V DC coil enables low-voltage control circuits
  • 6 A inductive rating handles motor loads directly
  • 1 NO auxiliary contact provides status feedback
  • DIN rail and panel mounting simplifies installation

Specifications

BrandEaton
TypeIndustrial Electrical Controls & Automation
ColorTransparent

Questions about this item

How do I mount the Eaton XTMC6A10TD on a DIN rail and wire the screw terminals correctly?

Clip the contactor onto a standard DIN rail until the latch engages, then insert each wire into the screw terminals and tighten the screws securely; the step often missed is confirming every conductor is fully seated before tightening.

Which parts of the Eaton XTMC6A10TD will need inspection or replacement after extended service?

The main power contacts and the single 1NO auxiliary contact are the wear items; check them periodically for pitting or overheating and replace the contactor if contact resistance rises or the coil fails to pull in at 24V DC.

What is the first limit reached when the Eaton XTMC6A10TD runs continuously at full inductive load?

The 6 A inductive current rating is the limiting factor; sustained operation at that level will cause the contact temperature to rise until the thermal limit of the contact materials is reached.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.