We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Grey rectangular IEC contactor with screw terminals and DIN rail clips

Eaton

Eaton XTCE015B01TD 3-pole contactor 24V DC 1NC

SKU CH-H9B3-XXNV3

3-pole IEC magnetic contactor with 24 V DC coil, 1 NC auxiliary contact, 15 A inductive rating and 1.2 million electrical cycles

  • TypeIndustrial Electrical Controls & Automation
  • 3-pole non-reversing design simplifies motor control circuits
  • 24 V DC coil enables low-voltage panel integration
  • 1 NC auxiliary contact provides ready status feedback
  • 15 A inductive rating handles typical industrial loads
  • 1,200,000 electrical cycles tested for long service life

Industrial 3-pole contactor

The Eaton XTCE015B01TD is a non-reversing IEC magnetic contactor with a 24 V DC coil and three power poles. It provides one normally closed auxiliary contact and uses screw terminals for wiring. The unit mounts on DIN rail or panel and carries UL, CSA, IEC 60947 and CE marks.

Suited for DC-coil control panels

It fits panels that need a 24 V DC coil and a single 1NC auxiliary for interlock or feedback circuits. The 15 A inductive and 22 A resistive ratings cover typical motor-starter and resistive-load duties. Buyers who need a reversing contactor, additional auxiliary contacts or an AC coil voltage should look at something else.

Screw terminals and open-frame IP20

Screw terminals allow standard ferrules or solid wire without special tooling. The open-frame IP20 construction means the contactor installs inside an enclosure supplied separately. The 1NC auxiliary is factory-fitted, so no extra accessory kit is required for basic interlocking.

Highlights

  • 3-pole non-reversing design simplifies motor control circuits
  • 24 V DC coil enables low-voltage panel integration
  • 1 NC auxiliary contact provides ready status feedback
  • 15 A inductive rating handles typical industrial loads
  • 1,200,000 electrical cycles tested for long service life

Specifications

BrandEATON
TypeIndustrial Electrical Controls & Automation

Questions about this item

What control circuit do I need to energise the 24 V DC coil on this contactor?

You need a 24 V DC power supply capable of delivering the coil's pick-up and holding current.

Will the 690 V AC rating and 15 A inductive / 22 A resistive capacity handle the same motor loads as my older IEC starter?

Yes, the contactor is rated for 690 V AC with 15 A inductive and 22 A resistive full-load current, matching typical IEC motor circuits of this frame size.

How can I verify the auxiliary contact changes state when the coil is energised?

Apply 24 V DC to the coil and measure continuity across the 1NC auxiliary terminals; the circuit should open when the coil is powered and close when power is removed.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.