Eaton
Eaton NGR25061BNAAN lighted rocker switch DPST 10 A 250 V 14 V indicator
A DPST rocker switch rated 10 A at 250 V AC with a 14 V incandescent indicator and 0.250 in quick-connect tabs
- DPST off/on control simplifies two‑circuit switching
- 14 V incandescent indicator shows status at a glance
- 10 A at 250 V AC rating handles demanding loads
- 250 in quick‑connect tabs speed up installation
- IP42 rating protects against dust and dripping water
Lighted rocker switch DPST
The Eaton NGR25061BNAAN is a lighted rocker switch with DPST contact form and seven connections. It suits panels that need a maintained off/on function with a built-in 14 V DC incandescent indicator. Rated for 10 A at 250 V AC and 15 A at 28 V DC, it meets CSA, RoHS and UL standards. The IP42 rating adds protection against limited dust and dripping water.
Panel mounting and wiring
The switch installs through a rectangular cut-out measuring 0.867 in by 1.734 in and uses 0.250 in quick-connect tabs for fast termination. Seven terminals handle both poles and the indicator circuit in a single mounting hole. Quick-connect tabs free up space behind the panel by eliminating screw terminals. The maintained action stays in the selected position until manually changed.
Thermals noise and power draw
The switch body carries no active cooling and operates silently with no moving parts beyond the rocker mechanism. Contact ratings of 15 A at 125 V AC and 15 A at 28 V DC define the maximum continuous current without overheating. The 14 V indicator draws only a small pilot current during the on state. IP42 sealing limits dust ingress that could increase resistance over time.
Highlights
- DPST off/on control simplifies two‑circuit switching
- 14 V incandescent indicator shows status at a glance
- 10 A at 250 V AC rating handles demanding loads
- 250 in quick‑connect tabs speed up installation
- IP42 rating protects against dust and dripping water
Specifications
| Brand | EATON |
|---|
Questions about this item
How much continuous current can the 250 V AC contacts carry before they become the limiting factor?
The AC contact rating is 10 A at 250 V, so sustained loads above that level will reach the switch’s current limit first.
What heat or noise should be expected when the switch runs all day at its rated load?
The switch itself has no moving fan or active cooling; heat is limited to normal contact resistance at 10 A 250 V AC, and operation is silent.
Which mating connectors or wire terminals are required to use the 0.250 in quick-connect tabs?
Standard 0.250 inch female quick-disconnect terminals crimped to the wire will plug directly onto the switch tabs.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
