Eaton
Eaton NGR15481BNAAN Lighted Rocker Switch
Lighted rocker switch with SPST on/on action, 14 V incandescent indicator, 0.250 in quick-connect tabs and IP42 rating
- Lighted indicator shows status at a glance
- SPST On/On function controls two circuits with one switch
- Quick-connect .250 in tabs speed up wiring
- Rated 15 A at 125 V AC and 15 A at 28 V DC
- Mounts in .867 x 1.734 in panel cut-out
Electrical starter with lighted rocker
The Eaton NGR15481BNAAN is a single-pole single-throw lighted rocker switch designed for machinery and machine-shop panels. It provides a maintained on/on function so the actuator stays in either position until moved again. A built-in 14 V DC incandescent indicator shows circuit status at a glance.
Quick-connect terminals for fast wiring
Each of the seven connections uses a 0.250 in quick-connect tab that accepts standard push-on terminals without soldering. The rectangular mounting hole measures 0.867 in by 1.734 in, matching common panel cut-outs in industrial equipment. Installation is completed by snapping the switch into the cut-out and pushing the tabs onto the wires.
Rated for 15 A at 125 V AC and 15 A at 28 V DC
The contacts carry 10 A at 250 V AC, giving headroom for typical control-circuit loads such as motor starters, solenoids and pilot lights. At 28 V DC the same 15 A rating applies, suitable for low-voltage DC controls. The IP42 enclosure resists dust and dripping water, but the switch is not sealed against immersion or high-pressure wash-down.
Highlights
- Lighted indicator shows status at a glance
- SPST On/On function controls two circuits with one switch
- Quick-connect .250 in tabs speed up wiring
- Rated 15 A at 125 V AC and 15 A at 28 V DC
- Mounts in .867 x 1.734 in panel cut-out
Specifications
| Brand | EATON |
|---|
Questions about this item
What does the 14 V DC incandescent indicator light mean for everyday use?
The built-in lamp glows when the switch is powered from a 14 V DC source, giving a clear visual cue that the circuit is live.
How do the 0.250 in quick-connect tabs limit the wiring options?
They accept standard 0.250 in female spade terminals, so you can push on pre-crimped leads without soldering.
What panel cut-out does the 0.867 in by 1.734 in mounting hole require?
Drill or punch a rectangular opening 0.867 in wide by 1.734 in high; the switch body then snaps securely into that aperture.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
