Eaton
Eaton M22M-DP-R-K11 push button 22 mm 1NO/1NC red IP67 IP69K
22 mm metal mushroom-head push button with 1NO/1NC contacts, red, IP67 and IP69K rated
- Engine BrandEATON
- Engine Size22 mm
- Momentary mushroom head gives quick emergency stop
- Metal 35 mm head resists impact in harsh areas
- 1NO/1NC contacts rated 6 A at 230 V AC
- IP67 and IP69K sealing blocks dust and high-pressure wash
- Certified to UL, CE, CSA and Bureau Veritas standards
Industrial Mushroom Push Button
The Eaton M22M-DP-R-K11 is a 22 mm non-illuminated mushroom push button designed for industrial control panels. It suits operators who need a momentary action switch with a distinct red metal head for emergency or standard machine functions.
Metal Construction and Sealed Mounting
The chrome die-cast aluminium bezel and metal mushroom head provide mechanical durability in harsh environments. Screw-clamp terminals allow secure wiring, while NEMA 1, 2, 3, 4, 4X, 13 and IP67, IP69K ratings confirm protection against dust, water jets and high-pressure washdown.
Contact Ratings Define Load Limits
The single operator carries a 1NO/1NC contact block rated at 6A at 230V AC and 3A at 24V DC under AC-15 and DC-13 duty. These ratings set the practical electrical limits; loads exceeding these values require a separate contactor or relay.
Highlights
- Momentary mushroom head gives quick emergency stop
- Metal 35 mm head resists impact in harsh areas
- 1NO/1NC contacts rated 6 A at 230 V AC
- IP67 and IP69K sealing blocks dust and high-pressure wash
- Certified to UL, CE, CSA and Bureau Veritas standards
Specifications
| Engine Brand | EATON |
|---|---|
| Engine Size | 22 mm |
Questions about this item
What contact rating does the 22 mm push button provide at 24 V DC and 230 V AC?
The contacts are rated 3 A at 24 V DC and 6 A at 230 V AC with AC-15 and DC-13 designations.
What panel cut-out and bezel dimensions suit the 35 mm metal mushroom head?
It fits a standard 22 mm mounting hole and uses a chrome die-cast aluminium bezel.
How do you wire the screw-clamp terminals on the 1NO/1NC contact block?
Strip the wire, insert it into the screw clamp and tighten the screw — do not solder the connection.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
