Eaton
Eaton E50SA Cutler-Hammer Limit Switch Body 1NC/1NO NEMA 1, 2, 4, 6, 6P, 12, 13 IP67
Limit switch body with 1NO/1NC contacts, rated 10 A at 12 V, NEMA 1, 2, 4, 6, 6P, 12, 13 and IP67
- Reliable switching with 1NO/1NC contact form
- Durable IP67-rated enclosure resists dust and water
- Broad NEMA 1, 2, 4, 6, 6P, 12, 13 environmental protection
- Operates from -40 to 221 degrees Fahrenheit
- Meets CSA, RoHS and UL Listed standards
Eaton E50SA Limit Switch Body
This Eaton E50SA Cutler-Hammer limit switch body provides a 1NC/1NO contact configuration for E50 limit switch assemblies. It carries NEMA ratings 1, 2, 4, 6, 6P, 12 and 13 alongside an IP67 rating for dust and water ingress protection. The unit operates across a temperature range of -40 to 221 degrees Fahrenheit and meets CSA, RoHS and UL Listed standards. It is designed for industrial control circuits requiring reliable position sensing.
Suits E50 switch assemblies needing 10 A at 12 V
This body suits maintainers and OEMs completing or repairing E50 limit switches where a single normally open and normally closed contact pair is required. The broad NEMA and IP67 ratings support indoor and outdoor installations exposed to washdown, oil or temporary submersion. Buyers needing a different contact arrangement, a higher AC voltage rating, or a complete switch with actuator included should look at other models.
Contact form 1NO/1NC with 10 A AC rating
The decisive specification is the 1NO/1NC contact form rated at 10 A for 12 V AC. This defines the switching logic and current capacity available for the control circuit. Verify that the application voltage and current demand match this rating before installation.
Highlights
- Reliable switching with 1NO/1NC contact form
- Durable IP67-rated enclosure resists dust and water
- Broad NEMA 1, 2, 4, 6, 6P, 12, 13 environmental protection
- Operates from -40 to 221 degrees Fahrenheit
- Meets CSA, RoHS and UL Listed standards
Specifications
| Brand | EATON |
|---|
Questions about this item
Will the 1NO/1NC contact block work with my existing E50 limit switch head?
Yes, this body is designed for use with E50 limit switch heads and provides one normally-open and one normally-closed contact.
How can I verify the switch is operating correctly after installation?
Check that the contacts change state at the actuator trip point and that the enclosure seals remain intact for the IP67 rating.
Does the package include the operating head or actuator, or must I order them separately?
This is the switch body only; the operating head and actuator are sold separately for the E50 series.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
