Eaton
Eaton 8004K45N1V2 Rocker Switch DPST 4 Conn On/Off Screw 10A 250V IP54
A DPST rocker switch rated 10 A at 250 V AC with screw terminals and IP54 protection
- DPST contact form controls two circuits independently
- 10 A at 250 V AC handles mains-rated loads
- IP54 rating resists dust and water splashes
- Screw terminals give secure, tool-tightened connections
- cRUus, RoHS and UL E2702 certifications confirm compliance
DPST rocker switch for 10 A AC circuits
The Eaton 8004K45N1V2 is a double-pole single-throw rocker switch rated at 10 A 250 V AC and 15 A 125 V AC. It provides simple on/off control for machinery, automotive or industrial equipment that needs a compact panel-mounted device. The non-illuminated black actuator and IP54 rating make it suitable for indoor or sheltered outdoor use.
Verify panel cutout and wiring before ordering
Confirm the mounting hole measures 0.867 in by 1.734 in so the switch fits your panel. The four screw terminals accept ring or fork lugs; ensure your wire gauge matches the 10 A / 15 A ratings and that the circuit voltage does not exceed 250 V AC or 28 V DC. The switch carries cRUus and RoHS markings and meets UL E2702 requirements.
Replaces worn or missing panel switches
Use this unit to replace a failed DPST rocker of the same cutout and terminal style in control panels, motor starters or automotive dashboards. The upgrade is worthwhile when the original switch has lost its IP54 seal, shows contact pitting or lacks the cRUus listing now required by your inspection regime.
Highlights
- DPST contact form controls two circuits independently
- 10 A at 250 V AC handles mains-rated loads
- IP54 rating resists dust and water splashes
- Screw terminals give secure, tool-tightened connections
- cRUus, RoHS and UL E2702 certifications confirm compliance
Specifications
| Brand | EATON |
|---|
Questions about this item
Does the switch come with mounting hardware or do I need to buy screws separately?
The unit is a rocker switch with a 0.867 in x 1.734 in mounting hole and screw terminals; mounting screws are not included and must be sourced separately.
Should I choose the 10 A 250 V AC rating or the 15 A 125 V AC rating for my circuit?
Select based on your supply voltage: use the 10 A @ 250 V rating for 250 V AC circuits, or the 15 A @ 125 V rating for 125 V AC circuits.
What does the IP54 rating mean when the switch is installed in a panel?
IP54 means the front of the switch is protected against dust ingress and water splashes from any direction when properly mounted in a panel cut-out.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
