Eaton
Eaton 8004K28N1V2 rocker switch SPDT On/None/On screw terminals
SPDT rocker switch with screw terminals rated 10 A at 250 V AC and IP54 sealed
- SPDT On/None/On switching gives three-position control
- 15 A at 28 V DC rating handles heavy loads
- IP54 seal resists dust and water ingress
- 867 in x 1.734 in mounting hole fits standard panels
- cRUus, RoHS and UL E2702 marks confirm compliance
Eaton 8004K28N1V2 SPDT rocker switch
This Eaton 8004K28N1V2 rocker switch provides a maintained SPDT On/None/On action with three screw terminals. It is rated for 10 A at 250 V AC, 15 A at 125 V AC and 15 A at 28 V DC. The switch fits a 0.867 in by 1.734 in mounting hole and carries cRUus, RoHS and UL E2702 approvals with an IP54 rating. Non-illuminated black actuator suits industrial and automotive control panels.
Upgrade from momentary or lower-rated toggles
Replace momentary switches when a maintained position is required for steady-state circuits. The 3/4 hp rating supports small motor loads that exceed typical toggle limits. Screw terminals simplify field wiring compared to solder-lug alternatives. The jump is worth it when environmental sealing to IP54 and agency listings are mandatory for compliance.
Suits panel builders needing sealed SPDT control
Ideal for machinery, vehicle dashboards and equipment panels requiring a maintained On/None/On function with screw connections. Not for buyers who need illuminated actuators, momentary action, higher horsepower ratings or quick-connect terminals. Builders requiring double-pole or centre-off configurations should look at other switch families.
Highlights
- SPDT On/None/On switching gives three-position control
- 15 A at 28 V DC rating handles heavy loads
- IP54 seal resists dust and water ingress
- 867 in x 1.734 in mounting hole fits standard panels
- cRUus, RoHS and UL E2702 marks confirm compliance
Specifications
| Brand | EATON |
|---|
Questions about this item
What are the mounting-hole dimensions for the 8004K28N1V2 rocker switch?
The switch fits a rectangular cut-out measuring 0.867 in by 1.734 in.
How do you wire the screw terminals on this SPDT switch, and what mistake should be avoided?
Loosen each screw, insert the stripped wire, and tighten securely; the common error is reversing the two travel terminals so the On/On function operates backwards.
What maintenance does the IP54-rated switch need over its service life?
Periodically wipe the actuator and panel seal clean, check screw-terminal tightness, and replace the unit if the contacts no longer carry the rated 10 A at 250 V AC or 15 A at 28 V DC.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
