Dynaquip Controls
Dynaquip Controls EHH23ATE20H 1/2 in 600 psi 12V 24V IP66 2.5 sec trap
Electrically actuated 1/2 in two-way ball valve rated to 600 psi with 12V or 24V operation, IP66 protection and 2.5 second cycle time
- TypeDrain Components
- MaterialHAWA
- ColorTransparent
- Electrically actuated for remote flow control
- 600 psi rating handles high-pressure systems
- Dual 12V DC and 24V AC/DC voltage flexibility
- IP66 enclosure resists dust and water ingress
- 5 second cycle time enables rapid actuation
1/2 in Brass Ball Valve with Electric Actuator
This two-way ball valve uses a chrome-plated brass ball and a straight two-piece body rated for 600 psi. It suits plumbing or fluid-control systems that need automated on/off control with a 12V DC or 24V AC/DC supply. The IP66-rated actuator includes a heater, position indicator and thermal overload protection.
Actuation Speed and Voltage Limits
The actuator rotates 90 degrees in 2.5 seconds, so rapid cycling applications must allow for this dwell time. Operation is limited to the listed 12V DC and 24V AC/DC inputs; other voltages are not supported. The fail-last behaviour means the valve holds its position if power is lost.
Connection and Seal Compatibility Check
The valve has a 1/2 in female NPT inlet, so mating pipework must match this thread type and size. Seat material is RPTFE and seals are PTFE and FKM; verify chemical compatibility with the intended fluid. Ensure the installation environment meets the IP66 rating requirements.
Highlights
- Electrically actuated for remote flow control
- 600 psi rating handles high-pressure systems
- Dual 12V DC and 24V AC/DC voltage flexibility
- IP66 enclosure resists dust and water ingress
- 5 second cycle time enables rapid actuation
Specifications
| Type | Drain Components |
|---|---|
| Material | HAWA |
| Color | Transparent |
| Brand | Dynaquip Controls |
| Model | EHH23ATE20H |
Questions about this item
Should I pick the 12 V DC or the 24 V AC/DC version for my control panel?
Both voltages are built into the same actuator — apply 12 V DC or 24 V AC/DC to the same terminals and the valve will operate.
What does the 2.5 second cycle time mean when the valve is installed in a pipe?
The actuator rotates the ball through its full 90 degree stroke in 2.5 seconds, so the flow path opens or closes in that time once power is applied.
What does the IP66 rating limit in a wash-down area?
IP66 means the actuator enclosure is dust-tight and protected against powerful water jets, so it can withstand direct spray during equipment cleaning.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
Taylor Made 12" x 18" Jolly Roger Novelty Flag 1818 marine electronic
- Accessories



