Dynabrade Products
Dynabrade Products 59035 Dynorbital-Spirit Air Random Orbital Sander 0.25 hp 5 in
A 5-inch air random orbital sander with a 3/32-inch orbit, 0.25 hp motor and 12,000 RPM free speed for industrial finishing
- MaterialHAWA
- 25 hp motor delivers consistent sanding power
- 12,000 RPM free speed enables rapid material removal
- 3/32 in orbit diameter produces smooth finish
- 5 CFM average consumption suits smaller compressors
- Palm-grip design with lever throttle gives comfortable control
Dynorbital-Spirit 59035 Air Sander
The Dynabrade 59035 Dynorbital-Spirit is a new pneumatic random orbital sander built for industrial finishing work. It delivers 0.25 hp at a free speed of 12,000 RPM with a 3/32 in orbit diameter. The palm-style body measures 6 1/2 in overall length and uses a 5/16 in-24 spindle thread.
Suited for single-handed surface preparation
This tool suits operators who need a lightweight, lever-throttle sander for non-vacuum material removal on a 5 in pad. It requires a 90 psi supply and consumes 3.5 average CFM at 15 seconds or 14.0 CFM at full load. Buyers needing integrated dust extraction or variable speed control should look at other models.
5 in pad with 3/32 in orbit defines the finish
The 5 in pad diameter paired with the 3/32 in orbit diameter determines the aggressiveness and pattern quality on the workpiece. A 1/4 in NPT air inlet and minimum 1/4 in hose size complete the connection requirements. The rear exhaust directs airflow away from the work surface.
Highlights
- 25 hp motor delivers consistent sanding power
- 12,000 RPM free speed enables rapid material removal
- 3/32 in orbit diameter produces smooth finish
- 5 CFM average consumption suits smaller compressors
- Palm-grip design with lever throttle gives comfortable control
Specifications
| Brand | DYNABRADE |
|---|---|
| Material | HAWA |
Questions about this item
What size backing pad and spindle thread does the 59035 sander accept?
The sander takes a 5 in backing pad on a 5/16 in.-24 spindle.
What air supply and hose are required for proper installation?
Connect a 1/4 in NPT inlet to a 1/4 in minimum hose at 90 psi; the tool averages 3.5 CFM at 15 seconds and draws 14.0 CFM at full load.
How often should the rear exhaust muffler be cleaned or replaced?
Inspect the rear exhaust muffler regularly and clean or replace it when airflow noticeably drops to maintain 12,000 RPM free speed.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
