We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Compact 7 inch digital torpedo level with magnetic aluminium base and LCD display

DWL200 Electronic Torpedo Level 0.1° 7 inch

SKU CH-A6MM-D4GAA

A digital torpedo level with 0.1° resolution, magnetic base, auto-inverting display and 360° measurement range

  • IncludesMain Body
  • Dual tilt and angle gauge with Alternate Zero for relative surface measurements
  • Resolution ±0.1° at 0° and 90° plus ±0.2° from 1° to 89°
  • Strong magnetic base attaches securely to metal fences, saw blades and surfaces
  • Auto-inverting display with buzzer alerts at 0° and any preset angle
  • Hold button freezes readings across full 360° measurement range

DWL200 Torpedo Digital Level

The DWL200 is a 7-inch electronic torpedo level with a resolution of 0.1° at level and plumb. It combines a digital protractor, angle gauge and bevel gauge in one rugged ABS body with an aluminium base. Strong built-in magnets secure the tool to ferrous surfaces such as saw blades, fences or pipework for hands-free measurement.

Suited for trades needing fast angle checks

Electricians, carpenters and metalworkers who need to set or verify angles between two surfaces will benefit from the Alternate Zero function and auto-inverting display. A buzzer sounds at 0° and any preset angle, while a hold button freezes the reading. Builders who require a longer 24-inch level or waterproof housing for wet-site work should look at other models in the range.

Resolution and range decide fit

The sensor delivers ±0.1° at 0° and 90° and ±0.2° from 1° to 89°, with a selectable display in degrees, percent slope, mm/M or In/Ft. Measurement range covers 0° to ±90° across four quadrants for a full 360° span. If your workflow demands 0.05° resolution or IP-rated water resistance, this unit does not meet those specifications.

Highlights

  • Dual tilt and angle gauge with Alternate Zero for relative surface measurements
  • Resolution ±0.1° at 0° and 90° plus ±0.2° from 1° to 89°
  • Strong magnetic base attaches securely to metal fences, saw blades and surfaces
  • Auto-inverting display with buzzer alerts at 0° and any preset angle
  • Hold button freezes readings across full 360° measurement range

Specifications

IncludesMain Body

Questions about this item

How do I calibrate the DWL200 without a special fixture?

Place the level on a flat surface, run the on-board calibration routine, then rotate the unit and repeat; the sensor stores the factory reference with no external jig required.

What maintenance will the magnetic base and sensor need over time?

Wipe the aluminium base and magnets clean of metal swarf after each use, keep the ABS body dry, and re-run the calibration routine if readings drift beyond ±0.1°.

At what angle does the resolution change from 0.1° to 0.2° during continuous use?

The display shows ±0.1° at 0° and 90°, while any angle between 1° and 89° reads ±0.2°; this is the first precision limit you encounter under sustained measurement.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.