We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Square 2.5 inch neodymium tweeter black plastic housing single unit

DS18

DS18 PRO-TWN3 2.5" 200W 4Ω neodymium tweeter single

SKU CH-BP3C-N36MP

A 2.5-inch neodymium compression tweeter handling 50 W AES and 200 W peak with 107 dB sensitivity and a 1.6 kHz–20 kHz response, supplied with a 2.2 µF crossover

  • TypeSpeaker
  • Speaker Size0.5"
  • Crisp highs to 20 kHz from 107 dB sensitivity
  • 50 W AES and 200 W peak power handling
  • Compact 63 mm square fits tight baffle cutouts
  • Neodymium motor with Kapton former and CCAW voice coil
  • Includes 2.2 µF high-pass filter for easy wiring

DS18 PRO-TWN3 2.5" tweeter

The DS18 PRO-TWN3 is a 2.5-inch high-compression neodymium tweeter built for car-audio enthusiasts who want maximum high-frequency output. Its square 63 mm aluminium frame allows tight side-by-side mounting for a uniform wall of tweeters. Rated at 107 dB sensitivity, it delivers crisp, bright highs up to 20 kHz with authority.

Upgrade from factory tweeters

Factory dome tweeters typically lack the power handling and sensitivity needed for competition-level SPL. This unit handles 50 W AES continuous and 200 W peak, so it stays clean when driven hard. The jump is worth it when you are adding amplification and need a tweeter that will not compress or fail at high output.

4 Ω load with passive crossover

The 4 Ω nominal impedance and included 2.2 µF capacitor set a 2 kHz high-pass point, limiting low-frequency excursion. Without an active crossover you cannot adjust slope or crossover frequency. The Kapton former and CCAW voice coil handle heat well, but the 1.6 kHz lower limit means midrange duties must be covered by separate drivers.

Highlights

  • Crisp highs to 20 kHz from 107 dB sensitivity
  • 50 W AES and 200 W peak power handling
  • Compact 63 mm square fits tight baffle cutouts
  • Neodymium motor with Kapton former and CCAW voice coil
  • Includes 2.2 µF high-pass filter for easy wiring

Specifications

TypeSpeaker
Speaker Size0.5"

Questions about this item

What cutout diameter and mounting depth does the 2.5-inch tweeter need?

The front-mount baffle cutout is 2.12 inches and the mounting depth is 1.32 inches.

How do I connect the included 2.2 uF filter and where do I set the crossover?

Wire the 2.2 uF capacitor in series with the positive lead and set the high-pass crossover at 2 KHz.

When should I replace the PEN diaphragm or the 1-inch CCAW voice coil?

Replace them if output drops, distortion appears at high volume, or the voice coil rubs magnetically.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.