Drill America
Drill America DWC5-530-357 1-1/2" x 3" HSS annular cutter pneumatic accessory
High-speed steel annular cutter with Weldon shank for magnetic drill press use
- High-speed steel construction resists wear during general-purpose drilling
- 3/4" Weldon shank fits magnetic drill presses only
- Cuts only material needed for a clean, accurate hole
- Pilot pin included for precise hole alignment
- California Proposition 65 warning for cancer and reproductive-harm chemicals
Annular cutter for magnetic drills
This 1-1/2 inch high-speed steel annular cutter is built for magnetic drill presses with a 3/4 inch Weldon shank. It removes only the perimeter material to create clean holes quickly in general-purpose metalwork. The tool is not compatible with standard hand drills or conventional drill presses.
Sustained cutting in steel
High-speed steel construction balances hardness and toughness so the cutter resists wear during extended drilling sessions. It maintains consistent material removal without the heat buildup that can dull lesser alloys. California Proposition 65 warnings apply because the product contains listed chemicals.
Direct fit for mag presses
The 3/4 inch Weldon shank seats directly into compatible magnetic drill presses with no adapters required. Installation fails when users attempt to chuck the cutter into a standard drill or drill press, which the manufacturer explicitly forbids. A pilot pin is included to guide the cut.
Highlights
- High-speed steel construction resists wear during general-purpose drilling
- 3/4" Weldon shank fits magnetic drill presses only
- Cuts only material needed for a clean, accurate hole
- Pilot pin included for precise hole alignment
- California Proposition 65 warning for cancer and reproductive-harm chemicals
Specifications
| Brand | DRILL AMERICA |
|---|
Questions about this item
How much heat does the 1-1/2" x 3" HSS annular cutter generate during continuous magnetic-drill operation?
High-speed steel construction balances hardness and toughness for wear resistance, and cutting only the hole perimeter reduces friction compared with twist drills, keeping temperatures lower during extended use.
What equipment must I already own to use the 3/4" Weldon shank annular cutter?
A magnetic drill press with a 3/4" Weldon shank holder is required; the cutter will not work in a standard hand drill or conventional drill press.
Will the 1-1/2" diameter cutter fit the 3/4" Weldon arbor on my older magnetic drill press?
Yes, the 3/4" Weldon shank is the industry-standard interface for magnetic drill presses, so it mounts directly on any compatible machine regardless of age.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
