Drill America
Drill America DWC5-530-210 annular cutter 7/16" x 2" with pilot pin
High-speed steel annular cutter with 3/4" Weldon shank and pilot pin for magnetic drill press use only
- High-speed steel withstands general-purpose wear
- 3/4" Weldon shank fits magnetic drill presses
- Cuts only material needed for clean holes
- Pilot pin included for accurate alignment
- California Proposition 65 warnings apply
Annular cutter for magnetic drill press
The Drill America DWC5-530-210 is a high-speed steel annular cutter built for use with a magnetic drill press. It features a 3/4" Weldon shank that locks directly into the press. The tool is not compatible with standard hand drills or conventional drill presses. It suits metalworkers who need fast, clean holes in structural steel or plate.
Cuts only the hole perimeter under load
In sustained cutting the tool removes material solely around the hole circumference, leaving a solid slug. This reduces the torque and feed force required compared with a solid twist drill of the same diameter. High-speed steel construction balances hardness and toughness for wear resistance during repeated cuts in general-purpose ferrous metals.
Verify press compatibility and safety warnings
Confirm your magnetic drill press accepts a 3/4" Weldon shank before ordering. The cutter must not be used in a hand-held drill or bench-top drill press. California Proposition 65 notices advise that the product contains chemicals known to the state to cause cancer and birth defects or other reproductive harm.
Highlights
- High-speed steel withstands general-purpose wear
- 3/4" Weldon shank fits magnetic drill presses
- Cuts only material needed for clean holes
- Pilot pin included for accurate alignment
- California Proposition 65 warnings apply
Specifications
| Brand | DRILL AMERICA |
|---|
Questions about this item
Does the 3/4" Weldon shank annular cutter run cool enough for all-day magnetic drilling?
High-speed steel construction resists heat buildup during extended cuts, and the annular design removes only the hole perimeter to reduce friction.
What magnetic drill press do I need for the 3/4" Weldon shank to fit?
Any magnetic drill press with a 3/4" Weldon shank holder accepts this cutter; it will not work in standard drill chucks or hand drills.
Can I keep my older 3/4" Weldon magnetic drill and just swap in this 7/16" cutter?
Yes, the 3/4" Weldon shank matches legacy magnetic drill presses, so the cutter fits directly without an adapter.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
