Drill America
Drill America DWC5-530-160 annular cutter 1-9/16" x 1" HSS with pilot pin
High-speed steel annular cutter with 3/4" Weldon shank and pilot pin for magnetic drill press use
- Cuts only needed material for fast, efficient holes
- High-speed steel combines hardness and toughness for wear resistance
- 3/4" Weldon shank fits magnetic drill press only
- Pilot pin included for accurate hole alignment
- California Proposition 65 warnings for cancer and reproductive harm
1-9/16" HSS annular cutter
Drill America DWC5-530-160 is a high-speed steel annular cutter designed for magnetic drill presses. It produces a 1-9/16 inch diameter hole with a 1 inch depth of cut using a 3/4 inch Weldon shank. The tool suits metal fabrication shops and maintenance crews needing fast, clean holes in structural steel.
Weldon shank fits mag drills only
Installation is a direct push-fit into any magnetic drill press with a 3/4 inch Weldon receiver; no adapters or chucks are required. The included pilot pin centres the cutter and ejects the slug automatically. Using the cutter in a standard hand drill or conventional drill press will damage the tool and create a safety hazard.
Magnetic-drill operators cutting 1-9/16" holes
This cutter serves teams that regularly bore 1-9/16 inch diameter holes up to 1 inch deep in steel with a mag drill. It is not for handheld drilling, drill-press work, or holes of any other diameter or depth. Buyers needing different sizes or a hand-drill compatible bit should select another tool.
Highlights
- Cuts only needed material for fast, efficient holes
- High-speed steel combines hardness and toughness for wear resistance
- 3/4" Weldon shank fits magnetic drill press only
- Pilot pin included for accurate hole alignment
- California Proposition 65 warnings for cancer and reproductive harm
Specifications
| Brand | DRILL AMERICA |
|---|
Questions about this item
How can I confirm the DWC5-530-160 is cutting correctly after installing it in my magnetic drill press?
A clean, round hole with minimal burr and steady feed pressure shows the cutter is working as intended.
What comes with the DWC5-530-160 and what must I supply separately?
The package includes the HSS annular cutter and its matching pilot pin; you must provide a magnetic drill press with a 3/4" Weldon shank holder.
Which Drill America annular cutter size should I choose for a 1-9/16" diameter hole?
Select the DWC5-530-160; its 1-9/16" cutting diameter and 1" depth of cut match that requirement.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
