Drill America
Drill America DAM Series Carbide-Tipped Masonry Drill Bit 3/4" 6" Black Oxide Round Shank 118° Point
A carbide-tipped masonry bit with wide flutes for fast dust removal in brick, concrete and sandstone
- TypeDrill Accessories
- Carbide tips handle brick, concrete and sandstone
- Wide flutes remove dust quickly in softer materials
- Black oxide finish resists corrosion during use
- 118° point starts cleanly in masonry surfaces
- 6" overall length reaches deeper anchor positions
Carbide-Tipped Masonry Bit
The Drill America DAM series bit is a carbide-tipped masonry drill bit built for brick, concrete and sandstone. It fits portable electric drills and uses a 1/2 inch round shank for standard chucks. The black oxide finish adds corrosion resistance. Contractors and DIY users drilling anchor holes in masonry will find it suited to the task.
6-Inch Overall Length
The bit measures 6 inches overall, giving enough reach for typical anchor, expansion shield and toggle bolt installations. Wide spiral flutes clear dust quickly in softer masonry so the hole stays clean. Carbide tips are brazed to tough steel bodies and ground larger than nominal size to provide clearance for fasteners. Very hard aggregate or reinforced concrete will wear the cutting edges faster than softer brick.
118-Degree Conventional Point
The 118-degree conventional point is the single specification that decides whether this bit matches the application. It centres reliably in masonry without walking and cuts efficiently in brick, block and sandstone. Buyers who need a split-point geometry for harder stone or a reduced-shank design for smaller chucks should select a different bit.
Highlights
- Carbide tips handle brick, concrete and sandstone
- Wide flutes remove dust quickly in softer materials
- Black oxide finish resists corrosion during use
- 118° point starts cleanly in masonry surfaces
- 6" overall length reaches deeper anchor positions
Specifications
| Brand | Drill America |
|---|---|
| Type | Drill Accessories |
Questions about this item
Will the 1/2" round shank fit the chuck on my older corded drill?
The 1/2" round shank is a standard size that fits most portable electric drill chucks, including older models.
How can I check the 118° point is cutting cleanly in concrete?
The bit should produce consistent dust removal through the wide flutes without binding or excessive vibration during drilling.
Does the single bit come with any anchors or shields for installation?
The pack contains only the carbide-tipped masonry drill bit; anchors, expansion shields and toggle bolts must be purchased separately.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
