Drill America
Drill America ANC5-530-210 7/16" x 2" nACo Blue Annular pneumatic accessory
A nano-composite coated annular cutter for magnetic drill presses that cuts only the necessary material for fast, efficient holes in steel, cast iron, heated and stainless steels
- nACo coating extends cutter life by 30% over standard HSS
- Cuts steel, cast iron, heated and stainless steels efficiently
- nACo nano coating resists wear and high heat during drilling
- M2 high-speed steel removes only necessary material for clean holes
- 3/4" Weldon shank fits most magnetic drill presses
Drill America nACo Annular Cutter
This 7/16 inch annular cutter uses nACo Nano-Composite Blue coating to extend tool life up to 30 percent over traditional high-speed steel cutters. It is designed for magnetic drill presses only and cuts steel, cast iron, heated steel and stainless steel efficiently. The 3/4 inch Weldon shank fits most magnetic drill presses and a pilot pin is included.
For magnetic drill press users cutting tough metals
Suits operators who need fast, clean holes in difficult materials using a mag drill with a Weldon shank. Not for anyone using a standard hand drill or conventional drill press, as the shank and cutting geometry are incompatible with those machines. Buyers who need a different diameter or cutting depth should look at other sizes.
Simple Weldon shank installation
Insert the cutter into the magnetic drill press chuck and secure the set screws on the 3/4 inch Weldon shank. Fit the supplied pilot pin before starting the cut. The most common error is attempting to run the cutter in a hand drill or standard drill press, which causes poor performance and rapid tool wear.
Highlights
- nACo coating extends cutter life by 30% over standard HSS
- Cuts steel, cast iron, heated and stainless steels efficiently
- nACo nano coating resists wear and high heat during drilling
- M2 high-speed steel removes only necessary material for clean holes
- 3/4" Weldon shank fits most magnetic drill presses
Specifications
| Brand | DRILL AMERICA |
|---|
Questions about this item
What shank size must my magnetic drill press accept for the 3/4" Weldon Shank on this cutter?
The 3/4" Weldon Shank fits most magnetic drill presses, also called mag drills, and is not compatible with standard hand drills or drill presses.
Will the nACo Nano-Composite coating help when cutting the stainless steel I still work with?
The nACo coating increases tool life up to 30% compared to traditional HSS annular cutters and cuts difficult materials including stainless steels.
How can I confirm the pilot pin is correctly engaged after installing the cutter?
The cutter comes with a pilot pin; proper engagement is shown when the pin seats fully in the cutter's centre hole and the ejector spring moves freely during the cut.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
