Drill America
Drill America ANC5-530-178 1-15/16" X 1" nACo Blue pneumatic accessory
nACo Nano-Composite Blue coating extends tool life up to 30% over standard HSS annular cutters for efficient hole making in steel, cast iron and stainless steels
- nACo Nano-Composite coating extends tool life up to 30%
- Cuts steel, cast iron, heated and stainless steels efficiently
- M2 High Speed Steel removes only necessary material for fast holes
- 3/4" Weldon Shank fits most magnetic drill presses
- Includes pilot pin for immediate magnetic drill press use
Drill America 1-15/16" nACo Coated Cutter
The Drill America ANC5-530-178 is a 1-15/16 inch nACo Nano-Composite coated blue annular cutter built for magnetic drill presses. Its M2 high-speed steel construction removes only the necessary material for fast, efficient hole making in steel, cast iron, and heated or stainless steels. The 3/4 inch Weldon shank fits most magnetic drill presses, and a pilot pin is included for immediate use. This accessory is not intended for standard hand drills or conventional drill presses.
Sustained Cutting Performance with Nano Coating
Under continuous drilling pressure the nACo Nano-Composite coating provides extra protection against tool wear and high heat buildup. The coating increases tool life up to 30 percent compared to traditional HSS annular cutters, allowing the cutter to maintain cutting efficiency through difficult materials without rapid degradation. This design supports consistent material removal rates during extended operations in demanding alloys.
Magnetic Drill Press Interface Constraints
The 3/4 inch Weldon shank limits compatibility to magnetic drill presses that accept this specific shank size; it will not fit standard drill chucks or other press types. The cutter geometry and pilot pin system are engineered exclusively for mag drill workflows, so operators must verify their equipment matches this mounting standard before use. California Proposition 65 warnings apply for chemicals known to cause cancer and reproductive harm.
Highlights
- nACo Nano-Composite coating extends tool life up to 30%
- Cuts steel, cast iron, heated and stainless steels efficiently
- M2 High Speed Steel removes only necessary material for fast holes
- 3/4" Weldon Shank fits most magnetic drill presses
- Includes pilot pin for immediate magnetic drill press use
Specifications
| Brand | DRILL AMERICA |
|---|
Questions about this item
How much heat does the nACo Nano-Composite Blue coating withstand during all-day cutting?
The nACo Nano Coating provides extra protection against high heat and tool wear, increasing tool life up to 30% compared to traditional HSS annular cutters.
What shank size must my magnetic drill press have to accept this cutter?
This cutter has a 3/4" Weldon Shank that fits most magnetic drill presses, also called mag drills, and is for use with magnetic drill press only.
Can I keep my standard hand drill and use this annular cutter with it?
No, this cutter is for use with a magnetic drill press only and must not be used with a standard hand drill or drill press.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
