Drill America
Drill America ANC5-530-124 13/16" X 1" nACo Blue pneumatic accessory
A 13/16" annular cutter with nACo Nano-Composite Blue coating for magnetic drill presses, extending tool life up to 30% in steel and stainless steel
- nACo Nano-Composite Blue coating extends tool life up to 30%
- Cuts steel, cast iron, heated and stainless steels efficiently
- m2 High Speed Steel removes only necessary material for fast holes
- 3/4" Weldon Shank fits most magnetic drill presses
- Includes pilot pin for accurate hole alignment
Drill America 13/16" Annular Cutter
The Drill America ANC5-530-124 is a 13/16 inch annular cutter built for magnetic drill presses. It uses an M2 high-speed steel body with a nACo Nano-Composite blue coating. The tool targets metalworkers who need fast, clean holes in tough alloys.
Magnetic Press Only Constraint
This cutter fits a 3/4 inch Weldon shank and is engineered solely for magnetic drill presses. It must not be used in a standard hand drill or conventional drill press. The design removes only the hole perimeter for efficient cutting.
nACo Coating Extends Life
The nACo Nano-Composite coating increases tool life up to 30 percent compared to traditional HSS cutters. It provides extra protection against wear and high heat when cutting steel, cast iron, heated steel and stainless steel. A pilot pin is included.
Highlights
- nACo Nano-Composite Blue coating extends tool life up to 30%
- Cuts steel, cast iron, heated and stainless steels efficiently
- m2 High Speed Steel removes only necessary material for fast holes
- 3/4" Weldon Shank fits most magnetic drill presses
- Includes pilot pin for accurate hole alignment
Specifications
| Brand | DRILL AMERICA |
|---|
Questions about this item
Which Drill America nACo coated annular cutter size should I choose for a 13/16" hole?
Select the ANC5-530-124 model; it is manufactured with a 13/16" cutting diameter and a 1" depth of cut for that specific hole size.
What does the 30% tool life increase mean when cutting stainless steel on a mag drill?
The nACo Nano-Composite coating reduces wear and heat buildup, so the M2 high-speed steel cutter stays sharp longer in stainless, cast iron and heated steels.
Will the 3/4" Weldon shank fit my magnetic drill press directly?
Yes, the 3/4" Weldon shank is the standard fit for most magnetic drill presses; the cutter is not compatible with standard hand drills or drill presses.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
