Drill America
Drill America 5/8 in. x 1 in. nACo Blue Annular Cutter with Pilot Pin
Nano-composite coating extends life by 30 percent while cutting steel, cast iron and stainless on magnetic drill presses
- TypeDrill Bits
- nACo Blue coating extends tool life up to 30% versus traditional HSS
- Cuts steel, cast iron, heated and stainless steels efficiently
- Cuts only necessary material for fast, quality hole making
- 3/4 in. Weldon shank fits most magnetic drill presses
- Includes pilot pin for immediate use
5/8 in. Annular Cutter for Mag Drills
This annular cutter is sized at 5/8 in. diameter with a 1 in. cutting depth and carries a nano-composite blue coating. It is built for magnetic drill presses using a 3/4 in. Weldon shank and includes the pilot pin needed for alignment.
Weldon Shank and Pilot Pin Ready
The 3/4 in. Weldon shank fits most magnetic drill presses, also called mag drills, and the supplied pilot pin centres the cut from the start. The tool is designed only for magnetic drill presses and must not be used in a standard hand drill or conventional drill press.
Nano-Composite Coating Handles Heat
The nACo blue coating increases tool life by up to 30 percent over traditional high-speed steel cutters and resists wear in high-heat conditions. It cuts steel, cast iron, heated steels and stainless steels by removing only the necessary material for fast, efficient hole making.
Highlights
- nACo Blue coating extends tool life up to 30% versus traditional HSS
- Cuts steel, cast iron, heated and stainless steels efficiently
- Cuts only necessary material for fast, quality hole making
- 3/4 in. Weldon shank fits most magnetic drill presses
- Includes pilot pin for immediate use
Specifications
| Brand | DRILL AMERICA |
|---|---|
| Type | Drill Bits |
Questions about this item
How does the nACo blue nano-composite coating affect tool life compared to traditional HSS?
The nACo blue coating increases tool life up to 30% compared to traditional HSS annular cutters.
What shank size does this cutter use and which machines accept it?
It has a 3/4 in. Weldon shank that fits most magnetic drill presses.
What is the correct way to install the pilot pin and what mistake should I avoid?
Insert the supplied pilot pin into the cutter's centre hole before mounting; never use this cutter in a standard hand drill or drill press.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
