Drill America
Drill America 13/16 in. HSS Taper Length Twist Drill Bit 10 in
High-speed steel taper-length twist bit drills deep holes in iron, steel and wood with a 118° point and 6.125 in. flute length
- TypeDrill Bits
- Drills deep holes with 10 inch overall length
- Cuts steel and iron using high speed steel
- 118 degree point starts cleanly in many materials
- Black oxide finish holds coolant for longer tool life
- Round shank fits most drill chucks and holders
13/16 in. Taper Length Drill Bit
This 13/16 in. high speed steel twist drill bit is built for tasks that require reach beyond a standard jobber length. The 10 in. overall length and 6.125 in. flute length suit production, maintenance and portable drilling in a broad range of ferrous and non-ferrous materials.
Check chuck capacity and material suitability
Verify that your drill chuck or tool holder accepts a 13/16 in. straight shank before ordering. The 118° conventional point and black oxide surface treatment are intended for aluminum, cast iron, steel, wood, PVC and similar materials listed in the specifications.
Fits standard holders and frees reach for deep holes
The round straight shank works with a wide variety of tool holding systems without special adapters. The taper length design provides the extra flute and overall length needed for deeper holes while the black oxide finish holds coolant near the cutting edge for longer tool life.
Highlights
- Drills deep holes with 10 inch overall length
- Cuts steel and iron using high speed steel
- 118 degree point starts cleanly in many materials
- Black oxide finish holds coolant for longer tool life
- Round shank fits most drill chucks and holders
Specifications
| Type | Drill Bits |
|---|
Questions about this item
Does the 13/16 in. bit arrive alone or with a case and extra bits?
The package contains one 13/16 in. high-speed steel twist bit only; no case, no spare bits, no accessories are included.
Should I pick the 10 in. taper-length version or a shorter jobber bit for my drill press?
Choose the 10 in. taper-length bit when you need 6.125 in. of flute reach beyond standard jobber length for deeper holes in iron, steel or wood.
Will the 118° point and 13/16 in. straight shank work in my 1/2 in. chuck without slipping?
The shank matches the 13/16 in. cutting diameter, so it needs a chuck that opens at least that wide; a 1/2 in. chuck cannot grip it.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
