Disposer
A 3.13-inch rubber splash guard reduces disposal noise and blocks food splatter while fitting 80 mm feed openings
- Quieter disposal operation thanks to high-quality rubber construction
- Prevents food and water splashing back up during use
- Tool-free installation by dropping into the existing opening
- Oil, wear and heat resistant material for long service life
- Fits 3.13in or 80mm garbage disposal feed openings
3.13-inch disposal baffle
This rubber splash guard fits garbage disposers with a 3.13-inch feed opening. It replaces a worn or missing baffle to stop food and water from splashing upward during operation. The pliable design lets waste pass through while keeping debris inside the unit. Installation requires no tools and takes seconds from the top of the disposer.
Households with a 3.13-inch disposer throat
Suits owners who need a direct replacement for a standard 3.13-inch (80 mm) opening on compatible Insinkerator, Moen, Waste King or GE models. Builders or plumbers working with larger or smaller throat diameters, or with non-standard flange patterns, should verify dimensions before purchase because this guard will not seal correctly on other sizes.
80 mm outer diameter
The critical specification is the 80 mm (3.13 in) outer diameter that matches the disposer feed opening. Measuring the existing baffle or the disposer throat confirms fit; any other diameter means the guard will not sit flush and will allow splash-back or vibration noise.
Highlights
- Quieter disposal operation thanks to high-quality rubber construction
- Prevents food and water splashing back up during use
- Tool-free installation by dropping into the existing opening
- Oil, wear and heat resistant material for long service life
- Fits 3.13in or 80mm garbage disposal feed openings
Specifications
No published specifications for this item yet.
Questions about this item
How much does the 3.13 in splash guard cut down disposal noise?
The rubber baffle dampens the sound of grinding waste, giving a noticeably quieter kitchen while the disposer runs.
Will the 80 mm opening fit my Insinkerator or Waste King unit?
It is made for any disposer with a 3.13 in feed opening, covering Insinkerator, Moen, Waste King and GE models.
What tools are needed to swap in the new baffle?
No tools are required; just pull the old gasket out from the top and press the replacement into place.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
