DeVilbiss
DeVilbiss JGA-510-90FW Pressure Feed Sprayer 1.6 mm
Pressure-feed spray gun with a 1.6 mm nozzle and 10 in pattern, using 12 cfm at 45 psi
- ColorTransparent
- Pressure feed delivers medium-to-fast fluid flow
- 6 mm nozzle produces up to 10 in pattern
- 12 cfm air consumption at 45 psi operating pressure
- 1/4 in air inlet fits standard shop hoses
- Transparent body lets you monitor fluid level
DeVilbiss JGA-510 Pressure Feed Sprayer
This DeVilbiss JGA-510 is a conventional pressure-feed spray gun built for professional finishing work. It operates without an integrated cup, connecting directly to a remote fluid source via a 1/4 inch air inlet. The transparent body allows visual monitoring of fluid flow during application.
Suited for high-volume coating tasks.
The gun delivers a 10 inch pattern width using a 1.6 mm nozzle at medium to fast fluid speeds. It requires a compressor capable of supplying 12 cfm at 45 psi. Buyers needing a self-contained cup gun or a tool for low-air-consumption detail work should consider a different configuration.
1.6 mm nozzle handles medium to fast delivery rates
This nozzle size comfortably atomises standard viscosity coatings for broad coverage. Very high-solids or heavily filled materials may exceed the practical delivery capacity of the 1.6 mm tip. The pressure-feed design provides continuous flow for large panels but offers no cup capacity for small, intermittent jobs.
Highlights
- Pressure feed delivers medium-to-fast fluid flow
- 6 mm nozzle produces up to 10 in pattern
- 12 cfm air consumption at 45 psi operating pressure
- 1/4 in air inlet fits standard shop hoses
- Transparent body lets you monitor fluid level
Specifications
| Brand | DEVILBISS |
|---|---|
| Color | Transparent |
Questions about this item
What air compressor capacity is needed to run the 12 cfm @ 45 psi requirement?
You need a compressor that can deliver at least 12 cfm at 45 psi continuously; check the compressor's output rating at that pressure to match the gun's demand.
Will the 1/4 in air inlet fit my existing 1/4 in NPT hose fittings?
Yes, the 1/4 in air inlet uses standard NPT threads, so it connects directly to common 1/4 in NPT air hoses and quick-disconnect fittings.
How can I verify the 10 in pattern size is being achieved after setup?
Spray a test pattern on cardboard at your working distance; the fan width should measure approximately 10 inches when the fluid and air controls are properly adjusted.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
