We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Flat orange ribbon cable with connectors at both ends

DELL

DELL XPS 18 1810 1820 Touchscreen Ribbon Cable JXMM9

SKU CH-3ECH-FW31C

Genuine Dell OEM touchscreen digitizer ribbon cable for XPS 18 1810 and 1820 all-in-one tablets, part JXMM9

  • Genuine Dell OEM part ensures exact fit for XPS 18 1810 and 1820 models
  • Connects digitizer board to restore touchscreen function on compatible All-in-One tablets
  • Dell part number JXMM9 matches original specification for reliable replacement
  • Manufacturer code 1412-025NODE provides additional verification for correct part identification
  • New condition guarantees unused component ready for installation in XPS 18 systems

Genuine Dell OEM Touchscreen Ribbon Cable

This genuine Dell OEM ribbon cable carries the JXMM9 part number and connects the touchscreen digitizer board in the XPS 18 1810 and XPS 18 1820 all-in-one tablets. It is a direct replacement for a damaged or worn flex cable.

Replaces Failed Original Digitizer Flex

The cable restores touch input when the factory ribbon has cracked, developed intermittent contact or been severed during a screen swap. The repair is worth it when the tablet chassis and display panel remain intact and only the flex connection has failed.

Limited to XPS 18 1810 and 1820 Models

The part fits only the two listed XPS 18 variants; it will not mate with other Dell all-in-ones, newer XPS generations or third-party tablets. Buyers needing a cable for a different model must source the correct Dell part number for that system.

Highlights

  • Genuine Dell OEM part ensures exact fit for XPS 18 1810 and 1820 models
  • Connects digitizer board to restore touchscreen function on compatible All-in-One tablets
  • Dell part number JXMM9 matches original specification for reliable replacement
  • Manufacturer code 1412-025NODE provides additional verification for correct part identification
  • New condition guarantees unused component ready for installation in XPS 18 systems

Specifications

BrandDell

Questions about this item

Will this JXMM9 ribbon cable fit my XPS 18 1820 all-in-one tablet?

Yes, it is a genuine Dell OEM part listed as compatible with both the XPS 18 1810 and XPS 18 1820 models.

How do I install the digitizer ribbon cable correctly?

Power off the tablet, disconnect the battery, then seat the JXMM9 connector fully into the digitizer board socket with the gold contacts facing down before locking the retention flap.

When should I replace this touchscreen ribbon cable?

Replace it if the touchscreen shows dead zones, ghost touches, or fails to respond after a drop or hinge repair on your XPS 18 1810 or 1820.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.