We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Flat orange ribbon cable with connectors for Dell Venue 10 Pro 5056 digitizer

DELL

DELL Venue 10 Pro 5056 Touchscreen Digitizer Ribbon Cable 450.06808.0001

SKU CH-0W9W-5T7RX

Genuine Dell OEM ribbon cable connects the touchscreen digitizer to the motherboard on Venue 10 Pro 5056 tablets

  • Genuine Dell OEM part ensures exact fit
  • Connects digitizer to motherboard for touch function
  • Designed for Venue 10 Pro 5056 tablet
  • Part number 450.06808.0001 matches Dell specification
  • New condition guarantees reliable performance

Genuine Dell OEM Ribbon Cable 450.06808.0001

This is a genuine Dell OEM ribbon cable for the touchscreen digitizer. It connects the digitizer directly to the motherboard inside the Venue 10 Pro 5056 tablet. The part arrives new and matches the original factory specification.

Replaces Damaged Digitizer Flex Cable

It replaces a torn, creased or oxidised flex cable that causes dead zones, ghost touches or total digitizer failure. The jump is worth it when the screen glass is intact but touch input no longer registers correctly. No other tablet model uses this specific cable routing.

Handles Venue 10 Pro 5056 Touch Input Restoration

It comfortably restores full capacitive touch function on the 10 inch display assembly. It runs out if the digitizer glass itself is cracked or the motherboard connector is damaged, as this cable only bridges the two components.

Highlights

  • Genuine Dell OEM part ensures exact fit
  • Connects digitizer to motherboard for touch function
  • Designed for Venue 10 Pro 5056 tablet
  • Part number 450.06808.0001 matches Dell specification
  • New condition guarantees reliable performance

Specifications

BrandDell

Questions about this item

Will this ribbon cable fit my Dell Venue 10 Pro 5056 tablet?

Yes, the cable is a genuine Dell OEM part designed specifically for the Venue 10 Pro 5056 tablet. It connects the touchscreen digitizer directly to the motherboard.

How do I install the digitizer ribbon cable, and what is the common mistake to avoid?

Disconnect the battery first. Route the cable exactly as the original was seated, ensuring the connector locks fully into the motherboard ZIF socket. The common error is leaving the latch unlatched, causing touch failure.

When would this ribbon cable need to be replaced again?

Replace it if the touchscreen becomes unresponsive, registers ghost touches, or shows dead zones after a drop or hinge stress. Physical creasing or connector corrosion also requires a new cable.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.