We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Flat grey ribbon cable with black connectors for Dell OptiPlex 3240 all-in-one

DELL

Dell OptiPlex 3240 All-in-One LVDS LCD Cable YR99J

SKU CH-954G-J86EK

Genuine Dell OEM LVDS LCD cable for OptiPlex 3240 All-in-One desktops, part YR99J

  • Genuine Dell OEM part ensures reliable display connection for OptiPlex 3240 All-in-One
  • Exact match to Dell part number YR99J guarantees correct fit and function
  • Designed specifically for OptiPlex 3240 All-in-One desktop systems
  • New condition provides full service life without prior wear

Genuine Dell LVDS cable for OptiPlex 3240 All-in-One

This genuine Dell OEM part replaces the internal LVDS LCD cable in OptiPlex 3240 All-in-One desktops. It carries the video signal from the system board to the integrated display panel. The part number is YR99J. Buyers needing a cable for a different chassis or form factor cannot use this item.

Passive component with no thermal or power impact

The cable is a passive ribbon assembly that draws no power and generates no heat. It adds no audible noise during normal operation. No active cooling or power budget is required for this replacement part.

Highlights

  • Genuine Dell OEM part ensures reliable display connection for OptiPlex 3240 All-in-One
  • Exact match to Dell part number YR99J guarantees correct fit and function
  • Designed specifically for OptiPlex 3240 All-in-One desktop systems
  • New condition provides full service life without prior wear

Specifications

BrandDell

Questions about this item

How do I install the YR99J LVDS cable into the OptiPlex 3240 All-In-One?

Power down the system and disconnect the power cord. Remove the rear cover screws to access the internal chassis. Route the cable through the hinge channel, connect the display-end connector to the LCD panel socket, then attach the motherboard-end connector to the system board header. Reassemble the cover.

When should I consider replacing the YR99J cable in my OptiPlex 3240 All-In-One?

Replace the cable if the display shows persistent flickering, vertical lines, colour distortion, or a completely blank screen while an external monitor works normally. Physical damage such as pinched wires or cracked insulation near the hinge also requires replacement.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.