DELL
DELL NEC NP905J OEM Replacement Projector Lamp 210W 2000 Hrs
A 210W NSH lamp module rated for 2000 hours, supplied as a complete housing for quick NEC projector replacement
- TypeNSH
- Wattage210W
- Lamp Life2,000 Hrs.
- Ready-to-install module with genuine Philips NSH 210W bulb
- 2000-hour rated life reduces replacement frequency
- Manufactured under ISO 9001 quality controls
- OEM-compatible fit for NEC NP905J projectors
- New replacement lamp includes housing for immediate use
Direct-fit NEC projector lamp
The DELL NEC NP905J module delivers a new 210 W Philips NSH bulb inside a pre-assembled housing. It is built for NEC projectors that specify the NP05LP part number and need a drop-in replacement.
Replaces a dim or expired NP05LP unit
Swap this module when the original lamp reaches its 2 000-hour rating or when brightness drops below usable levels. The jump is worth it if the projector otherwise meets your resolution and connectivity needs.
Tool-less housing swap in minutes
Installation requires opening the projector lamp door, removing the old housing and sliding the new one into place until it seats firmly. The most common issue is forgetting to reset the lamp-hour counter in the projector menu after installation.
Highlights
- Ready-to-install module with genuine Philips NSH 210W bulb
- 2000-hour rated life reduces replacement frequency
- Manufactured under ISO 9001 quality controls
- OEM-compatible fit for NEC NP905J projectors
- New replacement lamp includes housing for immediate use
Specifications
| Brand | NEC |
|---|---|
| Type | NSH |
| Wattage | 210W |
| Lamp Life | 2,000 Hrs. |
Questions about this item
Does the NP905J lamp module ship as a complete housing that fits directly into the projector?
Yes, the NP905J module arrives fully assembled with the Philips NSH 210W bulb already seated in its housing, so it slides straight into the compatible NEC projector without any extra parts.
What is the correct sequence for installing the NP905J lamp, and which step is most often missed?
Power off and unplug the projector, let it cool completely, remove the lamp cover, release the retaining screws, pull the old module out, insert the new NP905J unit until it clicks, re-tighten the screws, replace the cover, then reset the lamp timer in the menu — the timer reset is the step users most frequently forget.
When will the NP905J lamp need replacement, and what indicates it is time?
The Philips NSH 210W bulb is rated for 2000 hours of use; the projector will typically show a replacement warning or reduced brightness when that limit is reached, signalling that a new NP905J module is required.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
CHIEF MANUFACTURING CMS018 18" 457 mm Fixed Extension Column projector accessory
- Extension Column
- Projector



