DELL
DELL NEC NP62J OEM Replacement Projector Lamp 200W
A replacement projector lamp module with a 200 W UHP bulb rated for 2,500 hours normal or 3,500 hours economy use
- TypeUHP
- Wattage200W
- Lamp Life2,500 (Normal) - 3,500 (Economy) Hrs.
- Ready to install with pre-assembled housing
- 200 W UHP lamp delivers 2 500 hours normal life
- Economy mode extends use to 3 500 hours
- Manufactured to ISO 9001 quality standards
- Supplied as a genuine OEM replacement module
Compatible Projector Lamp Module
This replacement lamp module fits NEC projectors using the NP62J designation and includes a pre-assembled Philips UHP 200W bulb inside its housing. It arrives ready to install without separate bulb handling.
Suitable for Standard Brightness Needs
Users who need the rated 2,500 hours in normal mode or 3,500 hours in economy mode will find this lamp matches the original specification. Buyers who require a higher-wattage light source or a different lamp form factor should look at other models.
Simple Housing Swap Installation
The fully assembled housing allows a straightforward swap by opening the projector lamp door and replacing the module. The most common issue is forgetting to reset the lamp-hour counter in the projector menu after installation.
Highlights
- Ready to install with pre-assembled housing
- 200 W UHP lamp delivers 2 500 hours normal life
- Economy mode extends use to 3 500 hours
- Manufactured to ISO 9001 quality standards
- Supplied as a genuine OEM replacement module
Specifications
| Brand | NEC |
|---|---|
| Type | UHP |
| Wattage | 200W |
| Lamp Life | 2,500 (Normal) - 3,500 (Economy) Hrs. |
Questions about this item
Which NEC projector models accept the NP62J lamp module?
The NP62J lamp module fits NEC projectors that list NP09LP or NP62J as the original lamp code. Check your projector manual for that exact part number before ordering.
Does the 200W UHP lamp run on the same ballast as the original NEC lamp?
Yes. The replacement uses a 200W Philips UHP bulb built to the same electrical spec, so it ignites and runs on the projector's existing ballast without modification.
How can I verify the lamp is operating correctly after installation?
Reset the lamp-hour counter in the projector menu, then confirm the image reaches full brightness and the timer starts counting from zero in Normal or Economy mode.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
CHIEF MANUFACTURING CMS018 18" 457 mm Fixed Extension Column projector accessory
- Extension Column
- Projector



