DELL
DELL NEC NP-PA721XJL OEM Replacement Projector Lamp 350W
A replacement projector lamp module with a 350 W UHP bulb and housing, ready for NEC projector installation
- TypeUHP
- Wattage350W
- Lamp Life3,000 (Normal) - 4,000 (Economy) Hrs.
- Ready-to-install module with genuine Philips UHP 350W bulb
- Up to 4,000 hours lamp life in economy mode
- 3,000 hours rated life in normal mode
- Manufactured to ISO 9001 quality standards
- OEM replacement matches NEC NP26LP specification
OEM Replacement Lamp for NEC Projectors
This new replacement module contains a Philips UHP 350W bulb pre-assembled in its housing, matching NEC part NP26LP. It is intended for owners of compatible NEC projectors who need a direct swap without separate bulb handling.
Build quality and installation
Each unit is manufactured to ISO9001 standards and tested for beam performance, ignition, voltage, connections and run-time. The complete housing means the lamp seats in the projector exactly as the original did, with no extra alignment steps required.
Lamp life and operating limits
Rated life is 3000 hours in normal mode and 4000 hours in economy mode. Brightness will gradually decline beyond these points, and the projector will eventually require another replacement module to maintain usable image output.
Highlights
- Ready-to-install module with genuine Philips UHP 350W bulb
- Up to 4,000 hours lamp life in economy mode
- 3,000 hours rated life in normal mode
- Manufactured to ISO 9001 quality standards
- OEM replacement matches NEC NP26LP specification
Specifications
| Brand | NEC |
|---|---|
| Type | UHP |
| Wattage | 350W |
| Lamp Life | 3,000 (Normal) - 4,000 (Economy) Hrs. |
Questions about this item
What lamp standard does the NP-PA721XJL use, and what wattage does it cap at?
It uses a UHP lamp rated at 350 W, which is the fixed power draw for this module.
What physical module fits the projector, and what housing is included?
The unit is a complete NP26LP assembly with a new Philips UHP bulb already mounted in its housing, ready to slide into the projector.
How is the lamp installed, and which step do people often miss?
Power off and cool the projector, remove the lamp cover, release the retaining screws, swap the entire NP26LP module, re-tighten the screws, replace the cover, then reset the lamp-hour counter in the menu so the 3 000 or 4 000 hour rating tracks correctly.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
CHIEF MANUFACTURING CMS018 18" 457 mm Fixed Extension Column projector accessory
- Extension Column
- Projector



