DELL
DELL NEC NP-ME301X OEM Replacement Projector Lamp 230W NSHA 4000 Hrs
Ready-to-install lamp module with 230 W NSHA bulb rated for 4,000 hours
- TypeNSHA
- Wattage230W
- Lamp Life4,000 Hrs.
- Ready-to-install module saves setup time
- Ushio NSHA 230W bulb delivers specified brightness
- Rated 4000 hours lamp life extends replacement interval
- ISO9001 manufacturing ensures consistent quality
- Direct OEM compatibility guarantees proper fit
Ready-to-install NEC NP-ME301X lamp module
This replacement module ships with a new Ushio NSHA 230W bulb already seated in its housing, so it fits directly into the NEC NP-ME301X projector without extra assembly. It is intended for owners of that projector who need a fresh light source. Buyers with different projector models cannot use this module.
4,000-hour rated life at 230 watts
The lamp is specified for 4,000 hours of typical operation before brightness drops to half its initial output. At 230 watts it delivers the lumen level the projector was designed for. Users who run the projector continuously for many hours each day will reach the rated limit sooner than occasional users.
ISO 9001 manufacturing and tested ignition
Each unit is produced under ISO 9001 quality controls and checked for beam performance, ignition reliability, voltage stability and run-time before it leaves the factory. The housing and bulb are assembled to match the original mechanical and electrical interface, so the projector’s cooling system handles the thermal load as designed. No separate fan or ballast changes are required.
Highlights
- Ready-to-install module saves setup time
- Ushio NSHA 230W bulb delivers specified brightness
- Rated 4000 hours lamp life extends replacement interval
- ISO9001 manufacturing ensures consistent quality
- Direct OEM compatibility guarantees proper fit
Specifications
| Brand | NEC |
|---|---|
| Type | NSHA |
| Wattage | 230W |
| Lamp Life | 4,000 Hrs. |
Questions about this item
Will the 230W NSHA lamp work with the existing power supply in my NEC projector?
The lamp is a direct replacement module built to the projector's original 230W specification, so it draws the same power the factory unit did.
How can I verify the new lamp is igniting and running correctly after installation?
Reset the lamp-hour counter in the projector menu; the counter should start at zero and the image should reach full brightness without flickering.
Does the NP16LP module include the housing or just the bare NSHA bulb?
The module ships as a fully assembled bulb-and-housing unit ready to install; no separate housing purchase is required.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
Tripp Lite U324-003-BK USB 3.0 cable USB-A to USB-A 3 ft
- USB
- Black


