We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Black rectangular projector lamp module with integrated Ushio NSHA 230W bulb and housing

DELL

DELL NEC ME310XG Projector Lamp 230W 4000 Hrs

SKU CH-D74X-TM4Q0

A 230 W NSHA lamp module rated for 4,000 hours, supplied as a complete housing for direct installation

  • TypeNSHA
  • Wattage230W
  • Lamp Life4,000 Hrs.
  • Ready-to-install lamp module saves setup time
  • 230 W Ushio NSHA bulb matches original brightness
  • 4,000-hour rated life extends replacement intervals
  • ISO 9001 manufacturing ensures consistent quality
  • Compatible with NEC ME310XG projector model

NEC ME310XG replacement lamp module

This NEC ME310XG replacement lamp module arrives as a complete housing with a new Ushio NSHA 230W bulb inside, so it fits straight into the projector without extra assembly. The lamp is rated for 4,000 hours of operation and is manufactured to ISO 9001 quality standards. Each unit undergoes checks for beam performance, ignition, voltage, appearance, connections and run-time before it ships. It is supplied new and ready for immediate installation.

Suits NEC ME310XG owners needing a drop

The module is built for the NEC ME310XG projector and uses the NP16LP part reference, making it a direct swap for the original lamp. Buyers who need a different wattage, a different socket type, or a lamp for another projector model cannot use this module. It is not intended for bare-bulb swaps or for projectors that require a separate housing assembly. The product is a single lamp unit only.

The 230 watt NSHA bulb rating decides compatibility

The lamp draws 230 watts from an NSHA type bulb, and this figure must match the projector's original specification for correct ignition and brightness. If the projector requires a different wattage or a different lamp technology, the module will not operate properly. The rated life of 4,000 hours applies when the projector runs in its standard operating mode. No other specification overrides this electrical requirement.

Highlights

  • Ready-to-install lamp module saves setup time
  • 230 W Ushio NSHA bulb matches original brightness
  • 4,000-hour rated life extends replacement intervals
  • ISO 9001 manufacturing ensures consistent quality
  • Compatible with NEC ME310XG projector model

Specifications

BrandNEC
TypeNSHA
Wattage230W
Lamp Life4,000 Hrs.

Questions about this item

Does the lamp module come pre-assembled in its housing so it fits the NEC ME310XG projector directly?

Yes, the module includes a new 230 W Ushio NSHA bulb already fitted inside the housing, matching the NP16LP form factor for direct installation.

What is the correct sequence for installing the NP16LP lamp module, and which step is most often missed?

Power off and unplug the projector, allow it to cool completely, open the lamp cover, remove the old module, insert the new one until it seats firmly, close the cover, then reset the lamp-hour counter in the menu — the counter reset is the step most frequently forgotten.

After roughly 4 000 hours of use, what part will need replacement and what should I check at the same time?

The entire NP16LP lamp module will need replacement once the 230 W NSHA bulb reaches its rated 4 000-hour life; while the projector is open, inspect and clean the air filters to maintain proper airflow for the new lamp.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.