DELL
DELL NEC M311W Projector Lamp 230W 4000 Hrs
Replacement lamp module with a 230 W Ushio NSHA bulb rated for 4,000 hours, supplied in a ready-to-install housing
- TypeNSHA
- Wattage230W
- Lamp Life4,000 Hrs.
- Ready-to-install module with bulb and housing
- 230 W NSHA lamp delivers 4000 hours of use
- Manufactured to ISO 9001 quality standards
- Tested for beam performance, ignition and voltage
- Compatible with NEC M311W projectors
Ready-to-Install NEC Projector Lamp
The DELL NEC M311W projector lamp ships as a complete module with the Ushio NSHA 230W bulb already mounted in its housing. No separate handling of the bare bulb is required, so the unit can be fitted straight into compatible NEC projectors. Each lamp is built to ISO 9001 quality standards and tested for ignition, voltage and run-time before dispatch.
Ideal for Direct Replacement.
This module suits technicians and AV teams who need a drop-in replacement for the NP16LP part number and want to avoid the alignment risks of bare-bulb installation. Buyers who intend to reuse an existing housing or who require a bare NSHA bulb without the cage should look at a different product, because this item is only sold as a fully assembled unit.
230 Watt NSHA Lamp Rated for 4,000 Hours
The lamp draws 230 W and carries a manufacturer-rated life of 4,000 hours in standard operating mode. Matching both the wattage and the hour rating to the projector's specifications is the single check that confirms this is the correct part.
Highlights
- Ready-to-install module with bulb and housing
- 230 W NSHA lamp delivers 4000 hours of use
- Manufactured to ISO 9001 quality standards
- Tested for beam performance, ignition and voltage
- Compatible with NEC M311W projectors
Specifications
| Brand | NEC |
|---|---|
| Type | NSHA |
| Wattage | 230W |
| Lamp Life | 4,000 Hrs. |
Questions about this item
How much power does the 230W Ushio NSHA lamp draw during continuous daily use?
The lamp is rated at 230W, so the projector will draw approximately that amount while the lamp is lit; actual system draw may be slightly higher due to ballast and fan losses.
What projector model must I already own for the NP16LP module to fit and ignite correctly?
This lamp module is built for the NEC M311W projector; it includes the correct housing and connector for that model only.
Will the NP16LP lamp work reliably in an older NEC projector that originally shipped with a lower-wattage lamp?
No, the NP16LP is engineered for the M311W’s 230W ballast and ignition profile; using it in a different chassis risks ignition failure or premature ageing.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
CHIEF MANUFACTURING CMS018 18" 457 mm Fixed Extension Column projector accessory
- Extension Column
- Projector



