We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Dell N884K 400W redundant power supply module for PowerEdge T310

DELL

DELL N884K 400W Redundant Power Supply T310 Switch Module

SKU CH-3P2C-BXWPT

400-watt redundant power supply module for PowerEdge T310 servers

  • 400 W output powers the PowerEdge T310
  • Redundant design keeps the server running during a supply failure
  • Part N884K matches the original Dell specification
  • 1 kg unit fits the standard chassis slot

Dell N884K 400W redundant supply

The Dell N884K is a 400 Watt redundant power supply module built for the PowerEdge T310 server. It provides a hot-swap power source that keeps the system running if the primary unit fails. This new component is intended for administrators who need continuous uptime in a tower chassis. The unit weighs 5.1 units and fits the designated bay without modification.

Replaces a failed or missing T310 module

This supply directly replaces a faulty or absent power module inside a PowerEdge T310, restoring full redundancy for the chassis. The upgrade is worth it when the server currently runs on a single unit and any power loss would halt operations. It is not for builders who need a higher wattage rating or a different form factor than the T310 bay allows.

Highlights

  • 400 W output powers the PowerEdge T310
  • Redundant design keeps the server running during a supply failure
  • Part N884K matches the original Dell specification
  • 1 kg unit fits the standard chassis slot

Specifications

BrandDELL

Questions about this item

Does the N884K 400W redundant supply fit directly into the PowerEdge T310 chassis?

Yes, the N884K is built for the PowerEdge T310 and slides into the server's redundant power bay without adapters.

What is the common mistake when installing this module in the T310?

Not pushing the unit until the latch clicks; a loose seat breaks the redundant circuit and the server will not recognise the second supply.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.