We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Small green circuit board with a silver power button and short ribbon cable attached

DELL

DELL Latitude E6400 Power Button Board H572N G895P

SKU CH-PZYQ-J33ET

Replacement power button board with ribbon cable for Dell Latitude E6400 palmrest G895P

  • Genuine Dell replacement restores power control
  • Exact match for palmrest G895P only
  • Includes ribbon cable for direct connection
  • Tested working pull guaranteed functional
  • Fixes on/off switching on Latitude E6400

Exact fit for Latitude E6400

This replacement power-button board carries Dell part number H572N and is designed solely for Latitude E6400 units that use palmrest assembly G895P. It restores the on/off switch and WiFi catcher function on the original touchpad palmrest. Buyers with a different palmrest part number cannot use this board.

Passive component, no thermal load

The board draws negligible power and generates no measurable heat or noise during normal operation. It connects through the existing ribbon cable to the motherboard and operates only when the power button is pressed. No additional cooling or power budget is required.

Ribbon cable included, screws not supplied

The listing provides the flex cable needed for installation, but mounting screws are absent and must be sourced separately. No driver, firmware or software bundle accompanies the part. Installation is a direct swap once the correct palmrest is confirmed.

Highlights

  • Genuine Dell replacement restores power control
  • Exact match for palmrest G895P only
  • Includes ribbon cable for direct connection
  • Tested working pull guaranteed functional
  • Fixes on/off switching on Latitude E6400

Specifications

BrandDell

Questions about this item

How do I install the H572N power button board on my Latitude E6400?

Remove the palmrest assembly, disconnect the old ribbon cable, connect the new board's ribbon cable to the motherboard header, then secure the board onto the G895P palmrest.

What maintenance will the H572N power button board require?

No scheduled maintenance is needed; if the button becomes unresponsive or the ribbon cable frays, replace the entire H572N board.

What is the first limit I will hit if I use the power button constantly?

The mechanical switch life and ribbon cable flex endurance determine longevity; heavy use will wear the tactile button or fatigue the cable first.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.